494391
15
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
6. Telephoning
Gi
OPERATING
INSTRUCTIONS
11Page
Changing the Loudspeaker Volume
Press the Ä button while the loudspeaker is switched on in order to
adjust the volume. There are 4 levels available for selection.
Compiling the Call Time
Compiling of the call time is started approx. 5 seconds after the call has
been taken or the phone number dialled. Even if the phone number dialled
is engaged, the phone number and duration of the call are stored in the
outgoing call memory.
Muting the Microphone
While a call is in progress, you can press the È/Ç button to switch off the
microphone. Press the button again to resume the call.
Using the R Button
If your telephone is connected to a PABX system, the R button is used
during a call to enable consultation with other subscribers and/or to forward
a call to them.
This function is also used by network operators to provide customers with
various other services. For details, contact your telephone network
operator.
1. Pick up the receiver or press the < button to make the call.
2. During the call, press the R button and dial the phone number of another
subscriber in order to consult with him or forward the call to him.
3. Press the R button in order to take the initial call back following
consultation
or
4. Replace the receiver to forward the call to the subscriber contacted.
Tip: The above information could vary according to the PABX system
used. Please read the information provided in the manuals
supplied with your PABX system.
Entering a Dialling Pause (É)
If the telephone is connected to a PABX, it may be necessary to enter a
dialling pause. Press the É button after entering the digit following which a
pause is required, e.g. 0 for an outside line (0P....). A É then appears in the
display to represent the pause. A pause can also be programmed for
entries in the phone book.
Dialling Phone Numbers from the List of Incoming
Calls
The telephone automatically saves information on the last 44 incoming
calls. Proceed as follows to dial a phone number from this call list:
1. Press the _ or ` button to open the call list.
2. Press the _/` buttons to select a phone number.
3. Pick up the receiver or press the < button to dial the number.
Tip: If a call from the same phone number is received several times,
only the last call and time is displayed.
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

olympia-4310

Suche zurücksetzen

  • Woher bekomme ich eine Bedienungsanleitung. Problem: Das die Weckfunktion ist ohne mein Wissen eingestellt worden und ich kann sie nicht abstellen. Eingereicht am 20-1-2018 14:06

    Antworten Frage melden
  • was bedeutet 14 J I Z im Display und wir bekomme ich es wieder weg Eingereicht am 19-10-2017 14:29

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Olympia 4310 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Olympia 4310

Olympia 4310 Bedienungsanleitung - Deutsch - 28 seiten

Olympia 4310 Bedienungsanleitung - Holländisch - 28 seiten

Olympia 4310 Bedienungsanleitung - Französisch - 28 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info