Operating elements
Switch "ON / OFF“ turns the unit on (position ON or I). The unit is ready for use.
The unit has a microswitch - cutting starts when paper is inserted.
Press switch FWD (forward). The cutting unit runs (always).
Paper can be inserted for cutting.
Push switch REV (reverse) to push back the paper.
Release Switch REV to shred the paper remaining in the cutting unit.
Lamp "power": The equipment is switched on and ready for use.
Lamp "HOT": The Shredder became too hot and switched off.
After cooling the equipment is ready for use again.
Intended use
The shredder may only be used to shred paper in the infeed slots provided.
The material to be shredded must be dry and must correspond to the specifications li-
sted in the technical data. Shredding other materials can lead to injuries (for example,
if solid material splinters) or damage to the device (destruction of the cutting unit, etc.).
Do not shred endless paper documents with this device. Remove all paper clips and
staples before feeding paper into the device.
The device may only be used indoors in dry rooms.
Starting up
- Take the device carefully out of the packaging.
- Plug the mains cable into the socket. Please observe the energy supply specifications
on the back of the device in your safety measures.
- The socket and the mains connection of the device must be freely accessible for
safety reasons so that the power supply can be disconnected in emergencies.
Paper supply
- Switch the device on with switch ON.
- Feed the paper to the cutting unit through the infeed slot.
- The device runs forwards and draws the paper in.
- The device switches off automatically after the shredding cycle. The motor carries on
running for another 2-3 seconds to remove the remaining paper from the cutting unit.
Caution:the sheet capacity given in the technical data may not be
exceeded as otherwise a paper jam will occur. Remember that the thickness of the
paper increases when it is folded and the recommended sheet capacity may be excee-
ded in this way. Reduce the quantity of paper fed if it is coarse fibre paper. it is recom-
mended not to fill the paper collection basket up to the cutting unit. This prevents
cut material becoming jammed in the cutting unit. Empty the paper collection basket at
regular intervals.
7