509044
110
Zoom out
Zoom in
Vorherige Seite
1/133
Nächste Seite
110
EN
Information
10
3
Adjust the settings for each group in the super control panel.
Flash intensity
value
250250 F5.6
0.0
0.0
P
3838
A Mode
TTL
M
Off
+5.0
TTL +3.0
1/8
LO
1
Ch
Group
• Select the ash control
mode and adjust the ash
intensity separately for
each group. For MANUAL,
select the ash intensity.
Normal ash/Super FP ash
• Switch between normal
ash and Super FP ash.
Communication light level
• Set the communication
light level to [HI], [MID],
or [LO].
Channel
• Set the communication
channel to the same
channel used on the ash.
Flash
intensity
Flash control
mode
Adjust settings for the
camera ash unit.
4
Attach the supplied ash unit and raise the ash head.
• After con rming that the built-in and remote ash units have charged, take a test shot.
Wireless ash control range
Position the wireless ash units with their remote sensors facing the camera. The following
illustration shows the approximate ranges at which the ash units can be positioned. The
actual control range varies with local conditions.
7m
5m
100°100°
50°
50°
50°
50°
60°
60°
30°
30°
30°
30°
# Cautions
We recommend using a single group of up to three remote ash units.
• Remote ash units cannot be used for second curtain slow synchronization or anti-shock
exposures longer than 4 seconds.
If the subject is too close to the camera, the control ashes emitted by the supplied ash
may affect exposure (this effect can be reduced by reducing the output of the supplied
ash by, for example, using a diffuser).
The upper limit of ash synchronization timing is 1/160 sec. when using the ash in
remote control mode.
Other external ash units
Note the following when using a third-party ash unit mounted on the camera hot shoe:
• Using obsolete ash units that apply currents of more than about 24 V to the camera hot
shoe X-contact will damage the camera.
• Connecting ash units with signal contacts that do not conform to Olympus speci cations
may damage the camera.
Use only with the camera in shooting mode M at shutter speeds slower than 1/160 s and
at ISO settings other than [Auto].
Flash control can only be performed by manually setting the ash to the ISO sensitivity
and aperture values selected with the camera. Flash brightness can be adjusted by
adjusting either ISO sensitivity or aperture.
• Use a ash with an angle of illumination suited to the lens. Angle of illumination is usually
expressed using 35-mm format equivalent focal lengths.
110

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Olympus E-PL5 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Olympus E-PL5

Olympus E-PL5 Bedienungsanleitung - Deutsch - 132 seiten

Olympus E-PL5 Bedienungsanleitung - Holländisch - 132 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info