Bedienungsanleitung Olympus FL-50R (Seite 5 von 36) (Englisch)

470768

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

42 43

1. Press the Power button to turn the electronic flash on.

• The control panel lights up and battery charging starts.

2. Ensure that the Charge lamp lights up.

•Replace the batteries if the time taken for the Charge lamp

to light up is longer than the values specified below.

Alkaline or Ni-Mn batteries: 30 sec.

Lithium, Ni-Cd or Ni-Mh batteries: 10 sec.

•If the Charge lamp and AUTO CHECK lamp blink alter-

nately, it means that the battery capacity is running low. In

this case, replace the batteries.

Memo: To perform test flash activation, press the Test button.

3. Press the Power button again to turn the electronic flash off.

Turn the electronic flash off in the following cases:

• Before mounting it on the camera or dismounting it from

the camera.

• When flash emission is not required.

• When not using the electronic flash.

LOADING BATTERIES

CR-V3

The batteries are available separately. Always use one of the following battery combinations.

• AA (R6) alkaline batteries (LR6 type) .................................. x 4

• AA (R6) Ni-Cd batteries ....................................................... x 4

• AA (R6) Ni-Mh batteries ....................................................... x 4

• AA (R6) Ni-Mn batteries (ZR6 type) ..................................... x 4

• AA (R6) lithium batteries (FR6 type) .................................... x 4

• Lithium battery packs (CR-V3 type) (Olympus LB-01) ......... x 2

• The AA (R6) manganese batteries cannot be used.

How to load the batteries

1. Open the battery compartment cover.

2. Insert the batteries with correct +/– polarity.

3. Close the battery compartment cover.

AA (R6) batteries

The following products (optional) can also be used as an external power supply:

FlashPowerGrip FP-1

FlashHighVoltageSet SHV-1

■Notes

• Do not mix old and new batteries or batteries of different types together.

• Remove the batteries when the electronic flash is not going to be used for a long period.

• Carry spare batteries when traveling or when using the flash in cold areas.

CHECKING BATTERIES

After loading the batteries, check the remaining battery capacity by turning the electronic flash on.

■Flash Interval and Flash Count

The following table shows the flash intervals and flash counts for various batteries. Data is

based on using batteries all of the same type.

Batteries used Flash interval Flash count

AA (R6) alkaline dry cell batteries (LR6 type) Approx. 6 sec. Approx. 150 times

AA (R6) lithium batteries (FR6 type) Approx. 7 sec. Approx. 170 times

AA (R6) Ni-Mn batteries (ZR6 type) Approx. 5 sec. Approx. 160 times

Lithium battery packs (CR-V3) Approx. 5 sec. Approx. 220 times

AA (R6) Ni-Cd batteries, 1000 mAh Approx. 4 sec. Approx. 110 times

AA (R6) Ni-Mh batteries, 1900 mAh Approx. 4 sec. Approx. 170 times

• The flash emission interval and count data were obtained from in-house tests at Olympus.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olympus FL-50R Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Olympus FL-50R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info