Bedienungsanleitung Olympus LS-20M (Seite 66 von 108) (Englisch)

538318

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

Low Cut Filter A n

The recorder has a Low Cut Filter function to

minimize low-frequency sounds and record voices

more clearly. This function can reduce noise from

air conditioners, projectors and other similar

noises.

[Off]:

Disables this function.

[100Hz]:

This setting will reduce the noise generated

from air conditioners or projectors. It is effective

for indoor recording.

[300Hz]:

Use this setting when sufficient effects cannot

be obtained with the [100 Hz] setting.

ote

• W

hen the [Input Jack] setting is set to [Line],

the Low Cut Filter function is disabled (☞ P.67).

Self Timer A n

The self-timer function allows a certain amount

of time to elapse after you fully press the REC (s)

button and then starts recording or shooting. Set

this function according to the purpose of recording

or shooting.

[Off]:

Disables this function.

[beep 5sec]:

A beep tone sounds for 5 seconds and the

PEAK/LED indicator light flashes from 3 seconds

before recording or shooting starts.

[beep 12sec]:

A beep tone sounds for 12 seconds and the

PEAK/LED indicator light flashes from 3 seconds

before recording or shooting starts.

[metalic5sec]:

A rhythm count tone sounds for 5 seconds and

the PEAK/LED indicator light flashes from 3

seconds before recording or shooting starts.

[metalic12sec]:

A rhythm count tone sounds for 12 seconds

and the PEAK/LED indicator light flashes from 3

seconds before recording or shooting starts.

otes

• T

o cancel the self-timer after it starts press the

STOP (4) button.

•

Self-timer shooting is automatically canceled

after one shot.

•

When the [LED] setting is set to [Off], the LED

does not flash during self-timer operation. After

the time set for the self-timer elapses, recording

or shooting starts automatically (☞ P.73).

•

When the [Beep] setting is set to [Off], beep

does not sound during self-timer operation.

After the time set for the self-timer elapses,

recording or shooting starts automatically (☞

P.73).

Notes

• T

he recording level will be automatically

adjusted when the recording level is set to

[Auto]. Set the recording level to [Manual] to

use the recording level adjustment feature.

•

When the unit is set to [Auto], the limiter

function will be disabled. When a loud sound

is produced the level meter will swing all the

way over to the right while recording and the

PEAK/LED indicator light will turn on. When

this happens the sound will be recorded in a

distorted manner since the recording level is too

high. If sound distortions do not disappear even

after the recording level has been adjusted,

change the setting for microphone sensitivity

(☞ P.65) and adjust the recording level again.

•

If too big sound is input, the noise may occur even

if [Rec Level] is set to [Auto] or [Limiter ON].

• The level can be adjusted from [01] to [12]. The

higher the number, the higher the level and the

larger the indicator position on the level meter.

Menu setting method

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olympus LS-20M Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Olympus LS-20M

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info