Bedienungsanleitung Olympus TG-3 (Seite 108 von 118) (Englisch)

546777

108

Zoom out

Zoom in

Vorherige Seite

1/118

Nächste Seite

108

Monitor

• Do not push the monitor forcibly; otherwise the image may become vague, resulting in a playback mode failure

or damage to the monitor.

• A strip of light may appear on the top/bottom of the monitor, but this is not a malfunction.

• When a subject is viewed diagonally in the camera, the edges may appear zigzagged on the monitor. This is not

a malfunction; it will be less noticeable in playback mode.

• In places subject to low temperatures, the monitor may take a long time to turn on or its color may change

temporarily. When using the camera in extremely cold places, it is a good idea to occasionally place it in a warm

place. The monitor exhibiting poor performance due to low temperatures will recover in normal temperatures.

• The monitor of this product is manufactured with high-quality accuracy, however, there may be a stuck or

dead pixel on the monitor. These pixels do not have any inﬂ uence on the image to be saved. Because of the

characteristics, the unevenness of the color or brightness may also be found depending on the angle, but this is

due to the structure of the monitor. This is not a malfunction.

Legal and Other Notices

• Olympus makes no representations or warranties regarding any damages, or beneﬁ t expected by using this unit

lawfully, or any request from a third person, which are caused by the inappropriate use of this product.

• Olympus makes no representations or warranties regarding any damages or any beneﬁ t expected by using this

unit lawfully which are caused by erasing picture data.

Disclaimer of Warranty

• Olympus makes no representations or warranties, either expressed or implied, by or concerning any content of

these written materials or software, and in no event shall be liable for any implied warranty of merchantability

or ﬁ tness for any particular purpose or for any consequential, incidental or indirect damages (including but not

limited to damages for loss of business proﬁ ts, business interruption and loss of business information) arising

from the use or inability to use these written materials or software or equipment. Some countries do not allow the

exclusion or limitation of liability for consequential or incidental damages or of the implied warranty, so the above

limitations may not apply to you.

• Olympus reserves all rights to this manual.

Warning

Unauthorized photographing or use of copyrighted material may violate applicable copyright laws. Olympus

assumes no responsibility for unauthorized photographing, use or other acts that infringe upon the rights of

or by any means, electronic or mechanical, including photocopying and recording or the use of any type of

information storage and retrieval system, without the prior written permission of Olympus. No liability is assumed

with respect to the use of the information contained in these written materials or software, or for damages

resulting from the use of the information contained therein. Olympus reserves the right to alter the features and

contents of this publication or software without obligation or advance notice.

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olympus TG-3 Seite 108

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Olympus TG-3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info