Bedienungsanleitung Omron M24-7 ABPM (Seite 15 von 28) (Englisch)

549548

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Software

The OMROM M24/7 programmed manually can be used with the OMRON BP

Tracker Software version 1.14.6 or newer.

Manual programming LCD displays:

Normal status: time is

displayed

10 second delay state: time

is displayed but with no

double-dot

1. measurement plan:

15/30 minute day/night

intervals

2. measurement plan:

20/40 minute day/night

intervals

3. measurement plan:

30/30 minute day/night

intervals

Programming in progress:

blinking signal

2.7. Batteries

The OMRON M24/7 ambulatory blood pressure monitor operates with two 1.5V

AA batteries or two 1.2V AA rechargeable batteries. Use only standard long-

life (alkaline) batteries, or standard NiCd or NiMH rechargeable batteries of the

proper size. Do not use lithium batteries. Do not mix different battery types, do not

mix new and old batteries. Never use batteries of low or unknown quality or pre-

used batteries, as they may not cover the power needs of the monitor, and they

may damage the monitor, as they may contain acidic electrolytes which may leak

and corrode electronic components. Never use batteries damaged in any way.

Should the batteries run down during a monitoring session, they can be replaced.

Monitoring will continue and data will not be lost. If you do not use the monitor, it is

advisable to remove batteries since they may run down due to the constant small

power consumption of the integrated circuits of the device. Data in the monitor

are not lost even if batteries run down or are removed. Used batteries may fall

under the category of hazardous waste and should be disposed of properly.

Important! It is strongly recommended to use freshly charged accumulators or new

batteries with every patient so that batteries do not run down during monitoring,

even in case of very high blood pressure values and/or a long monitoring session.

After inserting batteries in M24/7monitors, it is advised to check their voltage

before programming the monitors. Do not start a new monitoring session with

low batteries. The typical voltage for two fully charged rechargeable batteries

should be over 2,5 V, and for fresh alkaline batteries, over 3 V. It is possible

to check battery voltage with the START button. (Please check the Using the

buttons section for more details.)

Important! If a monitor is not used for a long period, the in-built backup cell

ensuring the operation of the internal clock may get discharged. In this case keep

freshly charged batteries in the monitor for at least one day; this will recharge the

backup cell. It is possible to use the monitor afterwards. If the backup cell is not

properly charged, the internal clock may work incorrectly, and the monitor may

not start measurements in due time.

A set of new, high capacity batteries will enable the OMRON M24/7 monitor to

perform 250 blood pressure measurements during a 24-48 hours long monitoring

session. If you opt to use alkaline batteries, choose high capacity, long-life

products to enable reliable operation. A small crossed battery sign on the LCD

shows low battery voltage.

IM_EN.indd 15 19/07/2012 14:30:02

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Omron M24-7 ABPM Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info