Bedienungsanleitung Onkyo C-7000R (Seite 34 von 36) (Englisch)

462132

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

• The disc is upside down. Load the disc with the label-

side facing up (➔ 15, 22).

• The disc is dirty. Remove the disc and clean it (➔ 15).

• If condensation appears, unplug the power cord and

leave the compact disc player more than 3 hours at room

temperature.

• Make sure the disc is standard. See “Disc Note” (➔ 15).

• CD-R/CD-RW that are not finalized cannot be played.

• Install the compact disc player somewhere free of

vibration.

• The disc is dirty. Remove the disc and clean it (➔ 15).

• The disc is very scratched. Replace the disc.

• No such track on the disc. Enter another number (➔ 24).

• The disc is dirty. Remove the disc and clean it (➔ 15).

• The disc is very scratched. Replace the disc.

• Turn off any special playback modes (e.g. repeat,

memory, or random).

• Make sure the audio cable is connected correctly

(➔ 17).

• Make sure that all audio connecting plugs are pushed in

all the way (➔ 17).

• Make sure that the connected component’s input jack

and the input settings are correct.

• Make sure that the connected component’s volume isn’t

set to the lowest level, and that the volume isn’t muted.

• The disc is either scratched or dirty, and disc information

cannot be properly read.

• Make sure that the disc is not scratched or dirty.

• Due to a scratched or dirty disc, playback may not

operate normally or the sound may be jumpy.

• Make sure the batteries have been installed with the

correct polarity (+/–) (➔ 10).

• Replace both batteries with new ones. (Do not mix

different types of batteries or new and old batteries.)

• The remote controller is too far away from the compact

disc player, or there’s an obstacle between them (➔ 10).

• The compact disc player’s remote control sensor is being

subjected to bright light (inverter-type fluorescent light

or sunlight).

• The compact disc player is located behind the glass

doors of a audio rack or cabinet.

Disc Playback

Can’t play a disc.

Disc playback skips.

Can’t enter track numbers for memory

playback.

It takes a long time to locate certain

tracks.

Can not play tracks in the disc’s playback

order.

External Components

No sound is heard from a connected

component.

Display Unit

The message “99 --:--” appears.

Remote Controller

The remote controller doesn’t work

properly.

Onkyo is not responsible for damages (such as CD

rental fees) due to unsuccessful recordings caused by

the unit’s malfunction. Before you record important

data, make sure that the material will be recorded

correctly.

The compact disc player contains a microcomputer

for signal processing and control functions. In very

rare situations, severe interference, noise from an

external source, or static electricity may cause it to

lockup. In the unlikely event that this should happen,

unplug the power cord, wait at least 5 seconds, and

then plug it again.

Before disconnecting the power cord from the wall

outlet, set the main power switch to OFF.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo C-7000R Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo C-7000R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info