Bedienungsanleitung Onkyo cbx 100 (Seite 48 von 52) (Englisch)

159955

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Troubleshooting

—Continued

Playback jumps.

• The CBX-100 is being subjected to vibration or the disc is scratched or dirty (see page 14).

• The volume may be too loud. Turn down the volume (see page 20).

Can’t add tracks to the playlist for memory playback.

• Make sure there’s a disc in the CBX-100. Also, you can only add valid track numbers. For example, if the CD contains

11 tracks, you cannot add track #12.

The disc will not play.

• Make sure the disc has been loaded correctly, with the label-side facing up.

• Check to see if the surface of the disc is dirty (see page 14).

• If condensation is suspected, turn on the CBX-100 and leave it for 1 hour before playing any discs.

• Some CD-R/RW discs may not be playable (see page 13).

It takes a long time for playback to start.

• It may take the CBX-100 a while to read CDs that contain many tracks or ﬁles.

Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t preset all stations, or

the FM ST indicator doesn’t light up when tuned to a stereo FM station.

• Check the antenna connections (see page 15).

• Change the position of the antenna (see page 30).

•Move the CBX-100 away from a nearby TV or computer.

• Cars or airplanes can cause noisy interference.

• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.

• Switch to Mono mode and listen in mono. The FM ST indicator will go off (see page 30).

•Move power cords as far away as possible from the CBX-100’s antenna.

• When listening to an AM station, noise may be heard when you operate the remote controller.

• If none of the above improves the reception, install an outdoor antenna (see page 16).

If a power outage occurs or the power cable is disconnected.

• If there’s no power for a long time, the radio presets will be lost. In this case, preset them again (see pages 31 and 32).

• The clock and timer settings will be lost. Set the clock and timers again. If AccuClock is working, the clock will be

set automatically (see pages 19, 38, and 40).

Can’t adjust the frequency of the radio.

• Use the TUNING [ ]/[ ] buttons to change the frequency of the radio (see page 30).

RDS doesn’t work.

• The FM station you are tuned to doesn’t support RDS.

• The radio signal is weak. Change the position of the antenna. If that doesn’t work, install an outdoor FM antenna (see

page 16).

The remote controller doesn’t work properly.

• Replace the battery with a new one.

• The remote controller is too far away from the CBX-100, or there’s an obstacle between them (see page 12).

• The CBX-100’s remote control sensor is being subjected to bright light (inverter-type ﬂuorescent light or sunlight).

• The CBX-100 is located behind the glass doors of a audio rack or cabinet.

CD Playback

Tuner

Remote Controller

CBX-100_En.book Page 48 Friday, September 15, 2006 5:02 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo cbx 100 Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo cbx 100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info