Bedienungsanleitung Onkyo CR-N755 (Seite 31 von 48) (Englisch)

492677

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Listening to the Radio

Tuning into weak stereo FM stations

If the signal from a stereo FM station is weak, it may be

impossible to get good reception. In this case, switch to

Manual Tuning mode and listen to the station in mono.

Tuning into stations by frequency

You can tune into AM and FM stations directly by

entering the appropriate frequency.

With the Auto Preset function, you can automatically

preset all of the FM radio stations available in your area

in one go. Presets make it easy to select your favorite

stations and eliminate the need to tune the radio

manually each time you want to change stations. The

Auto Preset function does not preset AM radio stations

(see page 32).

Tip:

• You can also use the [INPUT] button and

[MENU/ENTER] jog dial on the CD receiver.

Tuning into Radio Stations

Press the [TUNER] button repeatedly to

select “AM” or “FM”.

Press [ENTER] repeatedly. The AUTO

indicator appears.

• Auto Tuning Mode

The AUTO indicator appears and stereo radio

reception is possible.

• Manual Tuning Mode

The AUTO indicator is not displayed and radio

reception will be in mono.

Use the TUN [e]/[r] buttons to tune into a

station.

In Auto tuning mode, once a station is found,

tuning stops automatically.

Radio frequency step for AM and FM can be

changed as below:

(North American models)

10 kHz steps for AM, 0.2 MHz steps for FM.

(European and Asian models)

9 kHz steps for AM, 0.05 MHz steps for FM.

In Manual Tuning mode, the frequency stops

changing when you release the button. Press the

button repeatedly to change the frequency one step at

a time.

Tip:

• Press and hold the Play/Pause [1/3] button on

the CD receiver to switch between modes.

Press the [TUNER] button repeatedly to

select “AM” or “FM”, followed by the

[D.TUN] button.

Within 8 seconds, use the number buttons

to enter the frequency of the radio station.

For example, to tune to 87.5 (FM), press [8], [7], [5]

or [8], [7], [5], [0].

If you have entered the wrong number, you can retry

after 8 seconds.

Band Frequency

(Actual display depends on country)

Presetting FM Stations Automatically

(Auto Preset)

Press the [TUNER] button repeatedly to

select “FM”.

Press the [MENU] button, and then use the

Arrow [!]/["] buttons to select “Tuner

Setting”.

Press [ENTER].

Use the Arrow [!]/["] buttons to select

“AutoPreset”.

Press [ENTER].

A message requesting confirmation appears.

To cancel the Auto Preset function at this point, press

the [MENU] button.

To start the Auto Preset function, press

[ENTER].

Up to 40 stations can be preset and presets are stored

in frequency order.

Any existing presets will be deleted when the

Auto Preset function is run.

Auto Preset Caution!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo CR-N755 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo CR-N755

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info