Bedienungsanleitung Onkyo cs 220 cr505 d s7gx (Seite 34 von 36) (Englisch)

159069

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Troubleshooting—

Continued

Trouble Possible Cause Remedy

Reception is noisy, inter-

mittent, and the FM STE-

REO indicator ﬂickers?

You’re too far away from the transmitter.

Or, your FM antenna is in the wrong posi-

tion or pointing in the wrong direction. Or,

the station’s signal strength is poor.

Switch the FM MODE to MONO (page 24).

Adjust the position, height, and direction of

your FM antenna.

Install an outdoor FM antenna, preferably

one with many elements. Installing an out-

door antenna is a specialist’s job, so contact

your nearest dealer for advice (page 13).

The radio presets no longer

work?

The power cord has not been connected to a

wall outlet, or the power has been turned off

for an extended period.

Preset your favorite radio stations again

(page 25). The power cord must be plugged

into a wall outlet a few times each month in

order to preserve the presets (page 4).

For European models:

The RDS (Radio Data Sys-

tem) doesn’t seem to work?

The current FM station does not support

RDS.

Tune into a station that supports RDS

(page 26).

The signal strength is poor, or there’s too

much interference.

Install an outdoor FM antenna (page 13),

change the position or direction of your out-

door FM antenna, and keep it away from ﬂu-

orescent lights.

CD playback skips?

The CR-505 is subject to vibration.

Install the CR-505 somewhere free of vibra-

tion.

The disc is dirty. Remove the disc and clean it (page 32).

The disc is very scratched. Buy a new disc.

Noise is generated.

DTS CD is being replayed.

Do not replay DTS CD, which is not sup-

ported by the CR-505.

Can’t play a CD?

The disc is upside down.

Load the disc with the label-side facing up

(page 20).

The disc is dirty. Remove the disc and clean it (page 32).

Condensation has formed inside the CR-

505.

Remove the disc and leave the CR-505 turned

on for several hours until the condensation

has evaporated.

The CD-R/RW disc is nonstandard. See “Disc Notes” (page 31).

It takes a long time to read

CD/MP3.

It may take a longer time to read CD/MP3

with many track numbers.

This is not a malfunction.

It takes a long time to locate

certain tracks.

The disc is dirty. Remove the disc and clean it (page 32).

The disc is very scratched. Buy a new disc.

For European models:

Does not operate during the

ACCUCLOCK function

with a message “WAIT”

displayed.

Bad receiving conditions may interfere with

the setting of the clock using ACCU-

CLOCK function.

Press the [DISPLAY] button to disengage

ACCUCLOCK, and then set the clock manu-

ally.

For European models:

The clock is wrong?

CT (Clock Time) information has been

taken from a radio station in another time

zone.

Set ACCUCLOCK to use a speciﬁc station

(page 17).

For European models:

The CR-505 turns itself on

unexpectedly?

The ACCUCLOCK function is calibrating

the clock.

This is not a malfunction. The CR-505 will

turn itself off automatically when the ACCU-

CLOCK function has calibrated the clock.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo cs 220 cr505 d s7gx Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo cs 220 cr505 d s7gx

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info