Bedienungsanleitung Onkyo CS-245BT (Seite 29 von 36) (Englisch)

549883

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Troubleshooting—Continued

Audio performance.

• Audio performance will be at its best about 10 to 30 minutes after the CD receiver has been turned on and had time

to warm up.

• Using cable ties to bundle audio cables with speaker or power cables may degrade the sound quality, so don’t do it.

The disc will not play.

• Make sure the disc has been loaded correctly, with the label-side facing up.

• Check to see if the surface of the disc is dirty (see page 12).

• If condensation is suspected, turn on the CD receiver and leave it for 2 to 3 hours before playing any discs.

• Some CD-R/RW discs may not be playable (see page 12).

It takes a long time for playback to start.

• It may take the CD receiver a while to read CDs that contain many tracks or files.

Playback jumps.

• The CD receiver is being subjected to vibration or the disc is scratched or dirty (see page 13).

• The volume may be too loud. Turn down the volume (see page 16).

Can’t play MP3 Discs.

• Use only ISO 9660 Level 1 or Level 2 format discs (see page 12).

• The disc has not been finalized. Finalize the disc.

• Check whether the file format is supported (see page 12).

• MP3 files without a “.MP3” or “.mp3” filename extension are not recognized.

There’s no sound.

• Check if “iPod” appears on the display of the CD receiver. If “USB” appears, switch the connection mode to iPod

(see page 21).

• Make sure the CD receiver is turned on, the input source is set to iPod, and the volume is not set too low.

• Make sure that your iPod/iPhone/iPad is compatible with the system (see page 7).

The message “ERROR” is displayed.

• Try reconnecting your iPod/iPhone/iPad.

Can’t control your iPod/iPhone/iPad with the CD receiver’s remote controller.

• Your iPod/iPhone/iPad may not work soon after it is connected to the CD receiver with a USB cable. In this case, wait

a few moments until your iPod/iPhone/iPad wakes up.

• Depending on your iPod/iPhone/iPad model, its software version, or the content you’re playing, some functions may

not work as expected (see page 21).

• The iPod/iPhone/iPad might not be connected if its power is turned off, or if it is insufficiently charged. Check the

state of your iPod/iPhone/iPad.

The message “No Device” is displayed.

• Try reconnecting your iPod/iPhone/iPad.

Can’t recharge the iPod/iPhone/iPad.

• Check if “iPod” appears on the display of the CD receiver. If “USB” appears, switch the connection mode to iPod

(see page 21).

• Check the iPod/iPhone/iPad connection.

• Depending on the state of your iPod/iPhone/iPad, the CD receiver might not be able to charge it. Try using the

dedicated charging method provided for the iPod/iPhone/iPad.

CD Playback

iPod/iPhone/iPad

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo CS-245BT Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo CS-245BT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info