Bedienungsanleitung Onkyo DX-C390 (Seite 3 von 28) (Englisch)

476168

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Precautions

Recording Copyright

Unless it’s for personal use only, recording copy-

righted material is illegal without the permission of

the copyright holder.

AC Fuse

The AC fuse inside the DX-C390 is not user-service-

able. If you cannot turn on the DX-C390, contact

your Onkyo dealer.

Care

Occasionally you should dust the DX-C390 all over

with a soft cloth. For stubborn stains, use a soft cloth

dampened with a weak solution of mild detergent

and water. Dry the DX-C390 immediately after-

wards with a clean cloth. Don’t use abrasive cloths,

thinners, alcohol, or other chemical solvents,

because they may damage the ﬁnish or remove the

panel lettering.

Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE

FIRST TIME, READ THE FOLLOWING SEC-

TION CAREFULLY.

AC outlet voltages vary from country to country.

Make sure that the voltage in your area meets the

voltage requirements printed on the DX-C390’s rear

panel (i.e., AC 120 V, 60 Hz or AC 230 V, 50 Hz).

For North American model

Setting the [STANDBY/ON] switch to STANDBY

does not fully shutdown the DX-C390. If you do not

intend to use the DX-C390 for an extended period,

remove the power cord from the AC outlet.

For non-North American models

To completely shutdown the DX-C390, set the

[POWER] switch to the OFF position.

Never Touch This Unit

with Wet Hands

Never handle this unit or its power cord while your

hands are wet or damp. If water or any other liquid

gets inside this unit, have it checked by your Onkyo

dealer.

Installing This Unit

• Install this unit in a well-ventilated location.

• Ensure that there’s adequate ventilation all around

this unit, especially if it’s installed in an audio

rack. If the ventilation is inadequate, the unit may

overheat, leading to malfunction.

• Do not expose this unit to direct sunlight or heat

sources, because its internal temperature may rise,

shortening the life of the optical pickup.

•Avoid damp and dusty places, and places subject

to vibrations from loudspeakers. Never put the

unit on top of, or directly above a loudspeaker.

• Install this unit horizontally. Never use it on its

side or on a sloping surface, because it may cause

a malfunction.

• If you install this unit near a TV, radio, or VCR,

the sound quality may be affected. If this occurs,

move this unit away from the TV, radio, or VCR.

Moisture Condensation

Moisture condensation may damage this unit.

Read the following carefully:

When you take a glass containing a cold drink out-

side on a summer’s day, drops of water, called con-

densation, form on the outside of the glass.

Similarly, moisture may condense on the lens of the

optical pickup, one of the most important parts

inside this unit.

• Moisture condensation can occur in the following

situations:

— The unit is moved from a cold place to a warm

place.

—A heater is turned on, or cold air from an air

conditioner is hitting the unit.

— In the summer, when this unit is moved from

an air conditioned room to a hot and humid

place.

— The unit is used in a humid place.

• Do not use this unit when there’s the possibility of

moisture condensation occurring. Doing so may

damage your discs and certain parts inside this

unit.

If condensation does occur, remove all discs and

leave this unit turned on for two to three hours. By

this time, the unit will have warmed up and any con-

densation will have evaporated. To reduce the risk of

condensation, keep this unit connected to a wall out-

let.

This unit contains a semiconductor laser system and is

classiﬁed as a “CLASS 1 LASER PRODUCT.” So, to

use this model properly, read this Instruction Manual

carefully. In case of any trouble, please contact the

store where you purchased the unit. To prevent expo-

sure to the laser beam, do not try to open the enclosure.

DANGER:

VISIBLE AND INVISIBLE LASER RADIATION

WHEN OPEN AND INTERLOCK FAILED OR

DEFEATED. DO NOT STARE INTO BEAM.

CAUTION:

THIS PRODUCT UTILIZES A LASER. USE OF

CONTROLS OR ADJUSTMENTS OR PERFOR-

MANCE OF PROCEDURES OTHER THAN

THOSE SPECIFIED HEREIN MAY RESULT IN

HAZARDOUS RADIATION EXPOSURE.

On some products, this label is located on the rear

panel. It indicates that:

1. This unit is a CLASS 1 LASER PRODUCT and

employs a laser inside the cabinet.

2. To prevent the laser from being exposed, do not

remove the cover. Refer servicing to qualiﬁed per-

sonnel.

DX-C390_En.book Page 3 Wednesday, August 27, 2003 5:49 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo DX-C390 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo DX-C390

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info