Bedienungsanleitung Onkyo HT-R993 (Seite 6 von 70) (Englisch, Französisch, Spanisch)

577745

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

Step 1:

Connections

Instructions on how to connect speakers

Important

You have to change the setting if any of the speakers have



viewing the guidance displayed on the TV screen. Select

the item with the cursors of the remote controller and press

ENTER to confirm your selection. To return to the previous

screen, press RETURN. Press RCV and then HOME on

the remote controller, select "Setup" - "2. Speaker Setup" -

"Speaker Settings" - "Speaker Impedance" and set "6ohms"

(default value) to "4ohms".

1/2"-5/8"(12-15 mm)

Cut and remove the plastic coating from the end of the

speaker cable, twist the core and connect it to the terminal.

Make correct connection between the unit's jacks and

speaker's jacks (+ to + and – to –) for each channel. If

connection is wrong, a bass sound may become poor due to

reverse phase.

¼

The speaker terminals of the home theater package are colored for

easy identification. Connect a color-coated wire (+) of each speaker

cable to the corresponding speaker terminal of the same color.

Connect a subwoofer by connecting the LINE INPUT jack

to the PRE OUT SUBWOOFER jack as shown in the

previous section.

¼

Up to two subwoofers with built-in power amplifier can be connected

to this unit. Set the cut-off filter selection switch of the subwoofer to

DIRECT, if applicable. If the subwoofer does not have a cut-off filter

selection switch but has a cut-off frequency adjusting dial, turn it to

the maximum frequency. If your subwoofer does not have built-in

power amplifier, you can connect a power amplifier between the unit

and the subwoofer.

Note

Short-circuiting the + cable and – cable or contacting the

cable core to the rear panel of the unit may cause failure.

Also do not connect two or more cables to one speaker

terminal or one speaker to several terminals.

When using commercially available banana plugs:

tighten the speaker terminals to the end and then insert

the banana plugs. Do not insert the core of speaker cable

directly into the hole for banana plug of speaker terminal.

(North American model)

Other connections

AM/FM antenna connections

Connect the antennas to listen to AM/FM broadcast. When

listening to the broadcast for the first time, adjust the

antenna position and orientation to get the best reception.

AM loop antenna

(supplied)

Indoor FM antenna

(supplied)

Fix with a tack on

the wall.

(North American

models)

(European models)

Assemble the AM loop antenna (supplied).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo HT-R993 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo HT-R993

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info