Bedienungsanleitung Onkyo TA-RW144 (Seite 9 von 16) (Englisch)

608264

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Recording

Stopping recording

Press the e button.

Interrupting recording briefly

Press the t button.

9. Put the source component into

recording standby status.

• Temporarily stop CD (or LP) play.

• Rewind the tape to the portion you wish

to start playback.

10. Press the s button on this unit and

begin playing the source component.

You can also use the CD Synchro

Recording function if this unit is prop-

erly connected to an ONKYO CD player

bearing the z symbol.

Making good sound recordings

DUBB.STOP

Dolby Noise Reduction System

Dolby B NR is the system used in most cassette tape decks to

reduce the background noise that is inherent in all cassette tapes.

Dolby Laboratories then developed an even more effective noise

reduction system, Dolby C NR, in response to the demand for

increasingly better sound quality from cassette tapes.

Both Dolby noise reductions systems operate by boosting

signals during recording that fall below a certain input level.

Dolby B and C NR operate on the higher portions of the fre-

quency spectrum using what is called a “sliding band” technique.

This is because tape hiss is most prominent during the quiet, high

frequency portions of a recording. These same signals are then

reduced back to their original strength during playback, thereby

reducing the background noise by the same amount. In order to

operate only when necessary, the Dolby NR system has a varying

effect depending on the input level and frequency of the material

being recorded.

Dolby C NR is capable of reducing tape hiss by 10 dB more

than Dolby B NR. In addition to its noise reducing function,

Dolby C NR has an anti-saturation network that lowers high input

levels before recording them and returns the signals to their

original strength during playback. This raises the high-frequency

saturation level of cassette tapes to allow you to record signals

that would normally cause distortion. This system raises the

maximum output level of cassette tapes by more than 4 dB at 10

kHz.

Setting the Proper Recording Level

The recording level has an important effect on the sound quality a

tape will have when it is played back. A recording level that is

too high will cause distortion while one which is too low will

lower the signal-to-noise ratio resulting in a tape with excessive

“hiss noise.” It is particularly important to set the recording level

correctly with cassette tapes since they have a much thinner

magnetic coating than open reel tapes. The thin coating gives the

tape a comparatively low saturation level which can easily be

surpassed if the recording level is set too high.

The recording level indicators feature a peak-hold function for the

indicators from -6 dB through +6 dB. This can come in handy

when setting the recording level.

CD Synchro Recording System

Once the TA-RW244/144 is connected to a CD player bearing the

z mark (see page 12), press the s button of the CD player will

cause recording to start automatically on the TA-RW244/144.

1. Insert a cassette with the side to be recorded facing out.

2. Start the CD player.

3. Press the t button to place the unit in the recording standby

mode. Adjust the input level. When the recording level has

been set, stop the CD player.

4. Start the CD player again, and recording will begin simultane-

ously.

Notes:

1. Even if the CD player is stopped during recording, the cassette

deck will continue recording.

2. If the cassette deck is in the recording standby mode when the

CD is put in play, the deck will begin recording. When setting

recording levels, always start the CD first.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TA-RW144 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info