Bedienungsanleitung Onkyo TX-DS787 (Seite 13 von 76) (Englisch)

553756

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Rear panel facilities

Optical digital input terminal

An optical digital input terminal is

equipped with a protection cap. When

connecting, remove this cap. When not

using, put the cap back on the terminal.

COAXIAL Coaxial cable

OPTICAL Optical fiber cable

DIGITAL INPUT/OUTPUT

(coaxial and optical)

These are the digital audio inputs and outputs. There are 2 digital

inputs with coaxial jacks and 2 with optical jacks. The inputs

accept digital audio signals from a compact disc, LD, DVD, or

other digital source component. For digital output, there is 1

optical output. The digital outputs can be connected to MD

recorders, CD recorders, DAT decks, or other similar components.

• When using the digital inputs and outputs, make sure to also

connect the analog connections whenever possible.

• When using one of the optical input or output jacks, remove

the protective cap and keep it safely. When the jack is not used,

replace the protective cap.

• When using an optical input or output jack, always use an

optical fiber cable.

GND

Use this GND terminal for connecting the ground (or earth) wire if

a turntable is connected. Refer to “Connecting a turntable” on page

18.

z (RI)

By connecting the z connector as shown in the diagram below,

you can use the RC-390M remote controller to operate Onkyo

cassette tape decks and compact disc players that also have

Onkyo’s z connectors. Simply connect a remote control cable

from this connector to the z connector of the cassette tape deck

or compact disc player. An z remote control cable with a 3.5-

mm (1/8-inch) miniature two-conductor plug comes with every

cassette tape deck and compact disc player that has an z

connector.

• For remote control operation, the audio connection cables

must also be connected.

• The RC-390M remote controller does not support turntables.

• If the connected component has two z connectors, you can

use either one to connect to the TX-DS787. The other one can

be used to daisy chain with another component.

• For Onkyo DVD or MD players, you can control them by

simply pointing the RC-390M controller directly at the

component.

REMOTE

CONTROL

Ex: Onkyo CD player

Ex: Onkyo cassette tape deck

TX-DS787

z connector

PRE OUT

These jacks are for connecting auxiliary power amplifier.

ANTENNA

These jacks are for connecting the FM indoor antenna and AM

loop antenna that are supplied with the TX-DS787.

IR IN MAIN/IR IN ZONE 2

If the TX-DS787 is located inside a rack or cabinet that will not

allow infrared beams to reach the IR sensor, you will need to

connect a remote sensor to IR IN MAIN input to be able to use the

remote controller. Then install the remote sensor in an unblocked

location where you can easily point the remote controller.

To use the remote controller in the remote zone (Zone 2), which

may be far separated from the TX-DS787, connect a multiroom

system kit to the IR IN MAIN/IR IN ZONE 2 input.

To be able to use the remote controller through either the IR

IN MAIN or IR IN ZONE 2 inputs, you must connect one of

the following (sold separately):

• Onkyo’s Multi-Room System kits (IR Remote Controller

Extension System), or

• Multiroom A/V distribution and control systems from Niles

and Xantech

to name a few

COMPONENT VIDEO INPUT/OUTPUT

If your DVD player or other device has component video

connectors, be sure to connect them to these component video

connectors on the TX-DS787. The TX-DS787 has two component

video input connectors to obtain the color information (Y, P

B, PR)

directly from the recorded DVD signal or other video component

and one component video output connector to output it directly

into the matrix decoder of the display device. By sending the pure

DVD component video signal directly, the DVD signal forgoes the

extra processing that normally would degrade the image. The

result is vastly increased image quality, with incredibly lifelike

colors and crisp detail.

YPB PR RCA type

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-DS787 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-DS787

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info