Bedienungsanleitung Onkyo TX-NR 717 (Seite 57 von 148) (Englisch)

492647

Zoom out

Zoom in

Vorherige Seite

1/148

Nächste Seite

Advanced Operations

En-57

•When the “Powered Zone 2” setting is set to “Yes” and Zone 2

is turned on, the surround back and front high speakers cannot be

used.

•When the “Powered Zone 3” setting is set to “Yes” and Zone 3

is turned on, the surround and surround back speakers cannot be

used.

• The test tone is output at the standard level for THX, which is

0 dB (absolute volume setting 82). If you normally listen at

volume settings below this, be careful because the test tone will

be much louder.

For the center speaker and subwoofer, the level settings made

by using the Quick Setup are saved in this menu (➔ page 49).

Tip

• If you’re using a handheld sound level meter, adjust the level of

each speaker so that it reads 75 dB SPL at the listening position,

measured with C-weighting and slow reading.

Equalizer Settings

With the Equalizer settings, you can adjust the tone of

speakers individually with a 5-band equalizer. The volume

of each speaker can be set (➔ page 56).

■ Manual Equalizer

` On:

You can adjust the equalizer for each speaker

manually. Continue with the following procedure:

` Off

Tone off, response flat.

Note

• When the Direct or Pure Audio listening mode is selected, the

equalizer settings have no effect.

• If “Audyssey” is enabled, it prevails over this setting

(➔ page 60).

THX Audio Setup

■ Surr Back Speaker Spacing

` <1ft (<0.3m)

` 1ft-4ft (0.3m-1.2m)

` >4ft (>1.2m)

You can specify the distance between your surround back

speakers.

Note

• This setting is not available in any of the following cases:

–“Surround Back” is set to “None” (➔ page 55).

–“Surround Back Ch” is set to “1ch” (➔ page 56).

–“Powered Zone 2/3” is set to “Yes” (➔ page 55) and Zone

2/3 is turned on (➔ page 71).

■ THX Ultra2/Select2 Subwoofer

` No

` Yes

If you’re using a THX-certified subwoofer, set this setting

to “Yes”.

Note

• If the “Subwoofer” setting is set to “No”, this setting cannot be

selected (➔ page 55).

■ BGC

` Off

` On

You can apply THX’s Boundary Gain Compensation

(BGC) to compensate the perceived exaggeration of low

frequencies for listeners sitting very close to a room

boundary (i.e., wall).

Note

• This setting is only available if “THX Ultra2/Select2

Subwoofer” is set to “Yes”.

• If the “Subwoofer” setting is set to “No”, this setting cannot be

selected (➔ page 55).

■ Loudness Plus

` Off

` On

When the “Loudness Plus” setting is set to “On”, it is

possible to enjoy even subtle nuances of audio expression

at low volume. This is only available when the THX

listening mode is selected.

■ Preserve THX Settings

` Yes

` No

If this setting is set to “Yes”, Dynamic EQ and Dynamic

Volume have no effect in THX listening mode.

Note

• This setting is fixed at “Yes” if “Loudness Plus” is set to “On”.

■ Metadata Compatible

` On:

When Metadata Compatible is set to “On”, valid

metadata is transmitted via the HDMI connections,

and can be used by other devices in the system.

` Off

When Metadata Compatible is set to “Off”, metadata

is not transmitted via the HDMI connections.

Press w to select “Channel”, and then use e/r to

select a speaker.

Use q/w to select a frequency, and then use the e/r

to adjust the level at that frequency.

The volume at each frequency can be adjusted from

–6dB to 0dB

to +6dB in 1 dB steps.

Tip

• You can select: “63Hz”, “250Hz”, “1000Hz”, “4000Hz”, or

“16000Hz”. And for the subwoofer, “25Hz”, “40Hz”,

“63Hz”, “100Hz”, or “160Hz”.

• Low frequencies (e.g., 63Hz) affect bass sounds; high

frequencies (e.g., 16000Hz) affect treble sounds.

Use q to select “Channel”, and then use e/r to

select another speaker.

Repeat steps 1 and 2 for each speaker.

You cannot select speakers that you set to “No” or

“None” in the “Speaker Configuration”

(➔ page 55).

To be continued

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR 717 Seite 57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR 717

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info