553769
35
Zoom out
Zoom in
Vorherige Seite
1/97
Nächste Seite
35
Selecting the Appropriate Setting
for Your Connections—Continued
To accurately set the output levels, it is recommended
to use a handheld sound pressure level (SPL) meter.
Set the meter to C-weighting and slow averaging. A
Radio Shack
®
SPL meter or equivalent is
recommended. Using the internal channel noise
generators, set each channel so that you read a 75
decibel sound pressure level.
Using the remote controller
Conguring Input
Settings Suitable for
Your Connections
These input settings should be made so that the
TX-NR801/TX-NR801E is optimized for your connec-
tions. If the default settings suit your connections, you
do not need to change any settings.
If you connected an MD recorder to the TAPE jack on
the TX-NR801/TX-NR801E, you can have “MD”
appear when the TAPE source button is pressed.
1
Press the TEST button.
A pink noise will be emitted from the
front left speaker.
At this time, the volume of the pink noise
will automatically increase to a
predetermined reference level (0 dB).
2
Remember the volume level of this
noise and then press the CH SEL
button.
The TX-NR801/TX-NR801E will now
emit the pink noise from the center
speaker.
3
Using the LEVEL / buttons,
adjust the volume level of the
noise from the center speaker so
that it is at the same level as that
emitted from the front left speaker.
4
Use the CH SEL and LEVEL /
buttons to select other speakers
and adjust the volumes until all
speakers are adjusted to the same
level.
5
Press the TEST button to complete
the procedure.
To Change the Display of the Input
Source from TAPE to MD
Press and hold down the TAPE
source button on the TX-NR801/
TX-NR801E until the display
changes from TAPE to MD (approx.
3 seconds).
When you use the remote controller to
perform the procedure, on the remote
controller, press the RCVR button and
hold down the TAP button for three sec-
onds.
To return the display to its original
setting, perform the same procedure.
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT
/
PURE AUDIO STEREO
FM
MODE
MEMORY
ENTER
RE
TURN
SETUP
TUNING
PRESET
TAPETAPE
TAPE
TX-NR801/
TX-NR801E
Remote
controller
35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo TX-NR801 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info