553769
40
Zoom out
Zoom in
Vorherige Seite
1/97
Nächste Seite
40
Enjoying Music or Videos with the TX-NR801/TX-NR801E—Continued
Temporarily Changing the Speaker Output
Levels
To change the individual speaker volumes temporarily,
follow the procedure given below. Each channel can be
set between –12 and +12 decibels (between –15 and
+12 decibels for the subwoofer). Note that the speaker
volumes will return to the original settings when the
TX-NR801/TX-NR801E is put in the standby state.
Notes:
You cannot select a speaker if it is set to “No” or
“None” in the Speaker Config Sub-menu of the
Speaker Setup Menu.
To have your new speaker levels set here, overwrite
the settings at Setup Menu Speaker Setup Menu
Level Calibration Sub-menu, and press the TEST
button after you complete step 3 in the procedure
above.
Using the Sleep Timer (remote controller only)
With the sleep timer you can set the TX-NR801/
TX-NR801E so that it automatically turns off after a set
period.
Adjusting the brightness of the front display
You can adjust the brightness of the front display of the
TX-NR801/TX-NR801E using the DIMMER button on
the remote controller or on the TX-NR801/TX-NR801E
front panel (other than European models).
1
Press the RCVR MODE button.
2
Press the CH SEL button and
select the desired speaker.
3
Press the LEVEL or button to
adjust the volume level.
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT
/
PURE AUDIO STEREO
FM
MODE
MEMORY
ENTER
RE
TURN
SETUP
TUNING
PRESET
DISPLAY DIMMER
AUDIO SELECTOR
TEST
RCVR
SLEEP
DISPLAY
DIMMER
CH SEL
AUDIO SEL
LEVEL
/
Press the [SLEEP] button repeat-
edly to select the required sleep
time.
You can set the sleep time from 90 to 10
minutes in 10 minute increments.
The SLEEP indicator appears on the dis-
play when the sleep timer has been set,
as shown. The specified sleep time
appears on the display for about five sec-
onds, then the previous display reap-
pears.
To cancel the sleep timer, press the
[SLEEP] button repeatedly until the
SLEEP indicator disappears.
To check the remaining sleep time,
press the [SLEEP] button. Note that if
you press the [SLEEP] button while the
sleep time is being displayed, you’ll
shorten the sleep time by 10 minutes.
Using the sleep timer only for Zone 2:
If you are using the remote zone (Zone
2), it will turn off at the same time as the
main zone. If you want to set the sleep
function for Zone 2 only, set the sleep
function with main zone turned on and
then put the main zone into the standby
state.
Use the DIMMER button to select:
dim, dimmer, or normal
brightness.
Remote
controller
DIMMER
TX-NR801/
TX-NR801E
Remote
controller
40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo TX-NR801 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info