Bedienungsanleitung Onkyo TX-NR807 (Seite 121 von 148) (Englisch)

553771

121

Zoom out

Zoom in

Vorherige Seite

1/148

Nächste Seite

121

Multi Zone—Continued

Notes:

• Only analog input sources are output by the ZONE 2/

3 PRE OUT and ZONE 2/3 L/R speaker terminals.

Digital input sources are not output. If no sound is

heard when an input source is selected, check if it’s

connected to an analog input.

• You cannot select different AM or FM radio stations

for your main room and Zone 2/3. The same AM/FM

radio station will be heard in each room. For example,

if you have an FM station for the main room, that sta-

tion will also be used in Zone 2.

• When you connect Zone 2 speakers directly to the AV

receiver, listening modes that require surround back

speakers or front high speakers or front wide speakers

(6.1/7.1), such as Dolby Digital EX, DTS-ES, THX

Select2 Cinema, Dolby Pro Logic IIz height, and

Audyssey Dynamic Surround Expansion™ are

unavailable.

• When you connect Zone 3 speakers directly to the AV

receiver, listening modes that require surround speak-

ers are unavailable.

• When the input selector of Zone 2/3 is selected, power

consumption on standby mode slightly increases.

• While Zone 2/3 is on, u functions will not work.

Adjusting the Volume for Zones

Muting Zones

Adjusting the Tone and Balance of Zones

Notes:

• Zones can also be unmuted by adjusting the volume.

• The Zone 2 volume, tone, and balance function have

no effect on the ZONE 2 PRE OUT when the “Zone2

Out” setting is set to “Fixed” (page 119).

• The Zone 3 volume, and balance function have no

effect on the ZONE 3 PRE OUT when the “Zone3

Out” setting is set to “Fixed” (page 119).

• Even if you repeatedly press the remote controller’s

[ZONE] button to select zones, the last zone selection

will be retained once you have switched to other com-

ponents by pressing other REMOTE MODE buttons

after pressing the [ZONE] button.

Remote

controller

On the remote controller, press

the [ZONE] button repeatedly,

and then use the VOL [q]/[w]

button.

AV receiver

On the AV receiver, press the

[ZONE 2] or [ZONE 3] button (the

ZONE 2/3 indicator and Zone 2/3

selector on the display flashes)

and press [LEVEL] button

followed by the [e]/[r] buttons

within 8 seconds.

Remote

controller

On the remote controller, press

the [ZONE] button repeatedly,

and then press the [MUTING]

button.

To unmute a zone, on the remote

controller, press the [ZONE]

button, and then press the

[MUTING] button again.

AV receiver

On the AV receiver, press the

[ZONE 2] or [ZONE 3] button.

Press the AV receiver’s [TONE]

button repeatedly to select

“Bass”, “Treble” or “Balance”.

Use the Right [r] and Left [e]

buttons to adjust the bass, treble

or balance.

• You can boost or cut the bass or tre-

ble from –10 dB to +10 dB in 2 dB

steps.

• You can adjust the balance from 0 in

the center to +10 dB to the right or

+10 dB to the left in 2 dB steps.

TX-NR807_En.book Page 121 Tuesday, July 28, 2009 12:00 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR807 Seite 121

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR807

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info