Bedienungsanleitung Onkyo TX-NR808 (Seite 46 von 100) (Englisch)

645307

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

Speaker Configuration

With these settings, you can specify which speakers are

connected and a crossover frequency for each speaker.

Specify “Full Band” for speakers that can output low fre-

quency bass sounds adequately, for example, speakers

with a good sized woofer. For smaller speakers, specify a

crossover frequency. Sounds below the crossover fre-

quency will be output by the subwoofer instead of the

speaker. Refer to your speaker’s manuals to determine the

optimum crossover frequencies. If you set up your speak-

ers using Audyssey MultEQ Room Correction and

Speaker Setup, please make sure manually that any THX

speakers are set to “80Hz(THX)” crossover.

■ Subwoofer

` Ye s

Select if a subwoofer is connected.

` No:

Select if no subwoofer is connected.

■ Front

` Full Band

` 40Hz to 80Hz(THX)

to 100Hz, 120Hz, 150Hz,

200Hz

Note

•If the “Subwoofer” setting is set to “No”, the “Front” setting is

fixed at “Full Band”.

■ Center

, Surround

, Surr Back

*2*3*4*5

` Full Band

` 40Hz to 80Hz(THX)

to 100Hz, 120Hz, 150Hz,

200Hz

` None:

Select if no speaker is connected.

■ Front Wide

*1*2*4*6

, Front High

*1*2*4*5

` Full Band

` 40Hz to 80Hz(THX) to 100Hz, 120Hz, 150Hz,

200Hz

` None

Select if no speaker is connected.

Note

“Full Band” can be selected only when “Full Band” is

selected in the “Front” setting.

If the “Surround” setting is set to “None”, this setting cannot

be selected.

If the “Surround” setting is set to anything other than “Full

Band”, “Full Band” cannot be selected here.

If the “Speakers Type(Front)” setting is set to “Bi-Amp”

(➔ 45), this setting cannot be selected.

If the Powered Zone 2 is being used (➔ 71), this setting can-

not be selected.

If the “Powered Zone 2” setting is set to “Act” (➔ 71), this

setting cannot be selected.

■ Surr Back Ch

` 1ch:

Select if only one surround back speaker is con-

nected.

` 2ch

Select if two (left and right) surround back speakers

are connected.

Note

•If the “Surr Back” setting is set to “None” (➔ 46), this setting

cannot be selected.

■ LPF of LFE

(Low-Pass Filter for the LFE Channel)

` 80Hz, 90Hz, 100Hz, 120Hz

With this setting, you can specify the cutoff frequency

of the LFE channel’s low-pass filter (LPF), which can

be used to filter out unwanted hum. The LPF only

applies to sources that use the LFE channel.

■ Double Bass

With the Double Bass function, you can boost bass out-

put by feeding bass sounds from the front left, right, and

center channels to the subwoofer.

` On:

Double Bass function on.

` Off(THX):

Double Bass function off.

Note

• This function can be set only if the “Subwoofer” setting is set to

“Ye s”, and the “Front” setting is set to “Full Band”.

• If you’re using THX-certified speakers, select “Off(THX)”.

Speaker Distance

Here you can specify the distance from each speaker to the

listening position so that the sound from each speaker

arrives at the listener’s ears as the sound designer

intended.

■ Unit

` feet:

Distances can be set in feet. Range: “0.5ft” to

“30.0ft” in 0.5 foot steps.

` meters:

Distances can be set in meters. Range: “0.15m” to

“9.00m” in 0.15 meter steps.

(The default setting varies from country to country.)

This setting is set automatically by Audyssey MultEQ

Room Correction and Speaker Setup function (➔ 28).

This setting is NOT set automatically by

Audyssey MultEQ Room Correction and Speaker Setup

function (➔ 28).

This setting is set automatically by Audyssey MultEQ

Room Correction and Speaker Setup function (➔ 28).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR808 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR808

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info