62439
72
Zoom out
Zoom in
Vorherige Seite
1/150
Nächste Seite
72
Basic Operations—Continued
With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
If you need to cancel the sleep timer, press the [SLEEP]
button repeatedly until the SLEEP indicator disappears.
To check the time remaining until the AV receiver sleeps,
press the [
SLEEP
] button. Note that if you press the
[
SLEEP
] button while the sleep time is being displayed,
you’ll shorten the sleep time by 10 minutes.
For private listening, you can connect a pair of stereo
headphones (1/4-inch phone plug) to the AV receiver’s
PHONES jack.
Notes:
Always turn down the volume before connecting your
headphones.
While the headphones plug is inserted in the PHONES
jack, the speakers are turned off and the Headphone
indicator lights up. (The Powered Zone 2 speakers are
not turned off.)
When you connect a pair of headphones, the listening
mode is set to Stereo, unless it’s already set to Stereo,
Mono, Direct, or Pure Audio.
Only the Stereo, Direct, Pure Audio, and Mono listen-
ing modes can be used with headphones (the listening
modes available also depend on the currently selected
input source).
When the multichannel input is used, only the front
left and right audio can be heard in the headphones.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 1 dB steps.
Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10dB in 1dB steps.
Notes:
This setting is not available when the multichannel
Analog input is selected.
The tone can be adjusted for Speakers A or Speakers
B. The same values are used for both.
The tone control settings do not apply to the Direct,
Pure Audio, or THX listening modes.
You can display various information about the current
input source as follows.
The following information can typically be displayed:
* If the input signal is analog, no format information is displayed.
If the input signal is PCM, the sampling frequency is displayed.
If the input signal is digital but not PCM, the signal format and
the number of channels is displayed. For some digital input sig-
nals, including multichannel PCM, the signal format, number of
channels, and sampling frequency is displayed.
Information is displayed for about three seconds, then the previ-
ously displayed information reappears.
Using the Sleep Timer
Press the [RECEIVER] button,
and then press the [SLEEP] but-
ton repeatedly to select the
required sleep time.
The sleep time can be set from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set. The specified sleep time appears on
the display for about five seconds, then
the previous display reappears.
Using Headphones
Adjusting the Bass & Treble
1
Press the AV receivers [TONE]
button repeatedly to select Bass
or Treble for Front, Center, Sur-
round, SurrBack, or Subwoofer.
2
Use the Up [r] and Down [e]
buttons to adjust.
Displaying Source Information
Remote
controller
AV receiver
Press the [DISPLAY] button
repeatedly to cycle through the
available information.
Input source
Listening
mode
Signal format*
Sampling
frequency
72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo TX-NR906 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Onkyo TX-NR906

Onkyo TX-NR906 Bedienungsanleitung - Deutsch - 294 seiten

Onkyo TX-NR906 Bedienungsanleitung - Holländisch - 294 seiten

Onkyo TX-NR906 Bedienungsanleitung - Italienisch - 294 seiten

Onkyo TX-NR906 Bedienungsanleitung - Schwedisch - 294 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info