Bedienungsanleitung Onkyo TX-RZ730 (Seite 148 von 174) (Englisch)

686253

148

Zoom out

Zoom in

Vorherige Seite

1/174

Nächste Seite

148

Front Panel≫ Rear Panel≫ Remote≫

Contents

≫

Connections

≫

Playback

≫

Setup

≫

 AccuEQ

AccuEQ Room Calibration: Enable or disable the equalizer function that

corrects for sound distortion caused by the acoustic environment of the room.

To enable this setting, normally select "On (All Ch)", and to disable only the front

speakers, select "On (ex. L/R)". The setting can be set for each input.

Equalizer: Select "Preset 1" to "Preset 3" congured in "2. Speaker" - "Equalizer

Settings" in the Setup menu. When this is set to "O", the same sound eld

setting is applied to all ranges.

EQ for Standing Wave : Setting this "On" will control the eect of the standing

wave generated by the sound wave reected by wall or similar interfering with the

original sound wave.

Re-EQ, Re-EQ(THX): Adjusts the soundtrack with the enhanced high range so

that it suits a home theater.

In Re-EQ, the following listening modes can be used: Dolby Audio - DD, Dolby

Audio - DD+, Dolby Audio - DSur, Dolby Audio - TrueHD, Multichannel, DTS,

DTS-ES, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD Master Audio,

DTS Neural:X, DTS Express and DSD.

In Re-EQ(THX), the following listening modes can be used:

THX Cinema and THX Select Cinema.

• It cannot be set if the listening mode is Pure Audio (European, Australian and

Asian models) or Direct.

 Other

A/V Sync: If the video is behind the audio, you can delay the audio to oset the

gap. The setting can be set for each input.

• It cannot be set if the listening mode is Pure Audio (European, Australian and

Asian models) or Direct.

Music Optimizer: Improve the quality of the compressed audio. Playback sound

of lossy compressed les such as MP3 will be improved. The setting can be set

for each input. This works in signals whose sampling frequencies are 48 kHz or

less. The setting is not eective in the bitstream signals.

• It cannot be set if the listening mode is Pure Audio (European, Australian and

Asian models) or Direct.

Late Night: Enable small sounds to be easily heard in detail. It is useful when

you need to reduce the volume while watching a movie late night. You can enjoy

the eect only when playing the Dolby series and DTS series input signals.

• This function cannot be used in the following cases.

– When playing Dolby Digital Plus or Dolby TrueHD with "Loudness

Management" set to "O"

– When the input signal is DTS:X, and "Dialog Control" is not 0 dB

Center Spread: Adjust the width of the sound eld of the front channel when

playing in the Dolby Audio - DSur listening mode. To spread the width of the

sound eld to the right and left, set to "On". To concentrate the sound in the

center, set to "O".

• Depending on the speaker settings, "O" is applied.

Dialog Control: You can increase the volume of dialog portion of the audio up to

6 dB by 1 dB step so that you can hear the dialog easily in noisy atmosphere.

• This cannot be set for content other than DTS:X.

• Depending on the content, this function may not be selected.

HDMI Out: Select the HDMI OUT jack to output video signals from "MAIN",

"SUB", and "MAIN+SUB".

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-RZ730 Seite 148

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-RZ730

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info