Bedienungsanleitung Onkyo TX-SR303 (Seite 41 von 56) (Englisch)

645306

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Common Functions—Continued

With the sleep timer, you can set the AV receiver so that

it automatically turns off after a set period.

To cancel the sleep timer, press the [SLEEP] button

repeatedly until the SLEEP indicator disappears.

To check the remaining sleep time, press the [SLEEP]

button. Note that if you press the [SLEEP] button while

the sleep time is being displayed, you’ll shorten the sleep

time by 10 minutes.

You can connect a pair of stereo headphones (1/4-inch

phone plug) to the AV receiver’s PHONES jack for pri-

vate listening, as shown.

Notes:

•Always turn down the volume before connecting your

headphones.

• Speaker sets A and B are turned off while the head-

phones plug is inserted in the PHONES jack.

• When you connect a pair of headphones, the listening

mode is set to Stereo, unless it’s already set to Mono,

Stereo, or Direct.

• When the multichannel DVD input is selected, only

the front left and front right channels can be heard in

the headphones.

You can adjust the level of each speaker in speaker set A

while listening to an input source. These temporary

adjustments are cancelled when the AV receiver is set to

Standby.

Notes:

•You cannot use this function while the AV receiver is

muted.

• Speakers that are set to No or None in the Speaker

Conﬁguration cannot be adjusted.

■ Speaker Set B

While speaker set B is on, you can also adjust the levels

of the left and right speakers in speaker set B, from

–12 dB to +12 dB.

• These settings are stored when the AV receiver is set

to Standby.

• While speaker set B is on, you can adjust the levels of

the left and rigt speakers in speaker set A’s and the sub-

woofer.

■ Headphones

While a pair of headphones is connected, you can adjust

the volume of the left and right channels individually,

from –12 dB to +12 dB each.

• These settings are stored when the AV receiver is set

to Standby.

■ Multichannel DVD Input

While the multichannel DVD input is selected, you can

adjust the level of each 5.1 channel input individually,

from –12 dB to +12 dB. (–30 to +12 dB for the sub-

woofer.)

• These settings are stored when the AV receiver is set

to Standby.

• Individual speaker levels can also be adjusted in

“3. MultiLevel Setup” (see page 50).

Using the Sleep Timer

Press the remote controller’s

[SLEEP] button repeatedly to

select the required sleep time.

You can set the sleep time from 90 to 10

minutes in 10 minute steps.

The SLEEP indicator appears on the

display when the sleep timer has been

set, as shown. The speciﬁed sleep time

appears on the display for about ﬁve

seconds, then the previous display

reappears.

Using Headphones

SLEEP indicator

STANDBY/ON

PHONES

A SPEAKERS B

Adjusting Speaker Levels

Use the remote controller’s

[CH SEL] button to select each

speaker, and use the [LEVEL–]

and [LEVEL+] buttons to adjust

the volume.

You can adjust the volume of each

speaker from –12 dB to +12 dB

(–15 dB to +12 dB for the subwoofer).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-SR303 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-SR303

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info