Bedienungsanleitung Onkyo TX-SR702 (Seite 54 von 96) (Englisch)

645308

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

Basic Operation

—Continued

You can adjust the brightness of the display.

You can temporarily mute the output of the AV receiver.

With the sleep timer, you can set the AV receiver to auto-

matically turn off after a speciﬁed period.

If you need to cancel the sleep timer, press the [SLEEP]

button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV receiver sleeps,

press the [SLEEP] button. Note that if you press the

[SLEEP] button while the sleep time is being displayed,

you’ll shorten the sleep time by 10 minutes.

You can connect a pair of stereo headphones (1/4-inch

phone plug) to the AV receiver’s PHONES jack for pri-

vate listening, as shown.

Notes:

•Always turn down the volume before connecting your

headphones.

• The speakers are turned off while the headphones plug

is inserted in the PHONES jack. (Zone 2 speakers are

not turned off.)

• When you connect a pair of headphones, the listening

mode is set to Stereo, unless it’s already set to Stereo,

Mono, Direct, or Pure Audio (not American

TX-SR602). When you disconnect the headphones,

the previous listening mode is resumed.

• Only the Stereo, Direct, Pure Audio (not American

TX-SR602), and Mono listening modes can be used

with headphones. (The listening modes available also

depends on the currently selected input source.)

• When the multichannel input is used, only the front

left and right audio can be heard in the headphones.

On the TX-SR702E, when the Stereo or Mono listen-

ing mode is selected, audio is downmixed for a good

sound.

Setting the Display Brightness

Press the [RECEIVER] button,

and then press the [DIMMER]

button repeatedly to select:

• Normal+VOLUME light on.

• Normal+VOLUME light off.

• Dim+VOLUME light off.

• Dimmer+VOLUME light off.

Muting the AV receiver

Press the [RECEIVER] button,

and then press the [MUTING] but-

ton.

The output is muted and the MUTING

indicator ﬂashes on the display, as

shown.

To unmute the AV receiver, press the

[MUTING] button again, or adjust the

volume.

The Mute function is cancelled when

the AV receiver is set to Standby.

DIMMER

SLEEP

MUTING

Press

[RECEIVER]

ﬁrst

RECEIVER

DIMMER

RECEIVER

MUTING

Using the Sleep Timer

Press the [RECEIVER] button,

and then press the [SLEEP] but-

ton repeatedly to select the

required sleep time.

The sleep time can be set from 90 to 10

minutes in 10 minute steps.

The SLEEP indicator appears on the

display when the sleep timer has been

set, as shown. The speciﬁed sleep time

appears on the display for about ﬁve

seconds, then the previous display

reappears.

Using Headphones

RECEIVER

SLEEP

PHONES

TX-NR702,602_En.book Page 54 Monday, July 26, 2004 11:05 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-SR702 Seite 54

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-SR702

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info