Bedienungsanleitung Onkyo TX-SR8350 (Seite 57 von 60) (Englisch)

645319

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Troubleshooting

—Continued

The remote controller doesn’t work?

• Make sure that the batteries are installed with the cor-

rect polarity (page 9).

• Make sure that the remote controller is not too far

away from the AV receiver, and that there’s no

obstruction between the remote controller and the AV

receiver’s remote control sensor (page 9).

• Make sure you’ve selected the correct remote control-

ler mode (page 10).

• Make sure you’ve entered the correct remote control

code.

Can’t control other components?

• Make sure you’ve selected the correct remote control-

ler mode (page 10).

• If you’ve connected an -compatible Onkyo Mini-

Disc or CD recorder to the TAPE IN/OUT jacks, for

the remote controller to work properly, you must set

the display to MD or CD (see pages 31 and 53).

• The wrong remote control code has been entered.

• The entered remote control code may not be correct. If

more than one code is listed, try each one.

•With some AV components, certain buttons may not

work as expected, and some may not work at all.

•To control Onkyo components via , point the

remote controller at the AV receiver.

•To control Onkyo components without , or other

manufacturers’ components, point the remote control-

ler at that component.

Can’t record?

• On your recorder, make sure the correct input is

selected.

•To prevent signal loops and damage to the AV

receiver, input signals are not fed through to outputs

with the same name (e.g., TAPE IN to TAPE OUT, or

VIDEO 1 IN to VIDEO 1 OUT).

• When the Pure Audio listening mode is selected,

recording is not possible because no video signals are

output. Select another listening mode.

The sound changes when I connect my head-

phones?

• When a pair of headphones is connected, the listening

mode is set to Stereo, unless it’s already set to Stereo,

Mono, Direct, or Pure Audio (not North American

model).

The display doesn’t work?

• The display is turned off when the Pure Audio (not

North American model) listening mode is selected.

How do I change the language of a multiplex

source?

• Use the “Multiplex” setting on the “4. Audio Adjust”

menu to select Main or Sub (page 47).

The functions don’t work?

•To use , you must make an connection and an

analog audio connection (RCA) between the compo-

nent and AV receiver, even if they are connected digi-

tally (page 29).

Remote Controller

Recording

Others

The AV receiver contains a microcomputer for signal pro-

cessing and control functions. In very rare situations,

severe interference, noise from an external source, or

static electricity may cause it to lockup. In the unlikely

event that this happens, unplug the power cord from the

wall outlet, wait at least ﬁve seconds, and then plug it

back in again.

Onkyo is not responsible for damages (such as CD

rental fees) due to unsuccessful recordings caused by

the unit’s malfunction. Before you record important

data, make sure that the material will be recorded cor-

rectly.

To reset the AV receiver to its factory defaults, turn

it on and, while holding down the [VIDEO 1] button,

press the [STANDBY/ON] button. “Clear” will

appear on the display and the AV receiver will enter

Standby mode.

Before disconnecting the power cord from the wall out-

let, set the AV receiver to Standby.

TX-SR503_En.book Page 57 Friday, February 25, 2005 9:35 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-SR8350 Seite 57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info