HARDWARE DESCRIPTION 8
HARDWARE DESCRIPTION7
4.A. FRONT PANEL
1) ANTENNA (A/B)
: This port is to connect the coaxial cable. The IF input is provided through this port and
the input frequency range is 174 ~ 862Mhz.
2) LOOP OUT (A/B)
:
This is used to connect your digital receiver to your TV set so that you can
still Watch analogue programs. (2,7,9,10 & SBS)
3) SERIAL PORT
:
This port is used for software upgrades when connected to your computer
through a serial cable.(Not Supplied)
4) TV SCART : This is used to connect your TV via Scart leads.
5) VCR SCART : This is used to connect your VCR via Scart leads.
(When you connect external sets to above two SCART sockets, always use fully featured SCART
cables)
6) S/PDIF DIGITAL OUTPUT : This is for connecting digital optical audio to devices such as
surround sound amplifiers.
7) VIDEO, AUDIO R/L : These RCA connectors are used to connect the digital receiver to any
external device with RCA inputs. (TV set, Video, Projetor etc)
8) ANT IN : To be looped from TV OUT when connecting the digital receiver via RF to your TV.
9) TV OUT : Used to connect the digital receiver via RF to your TV.
10) POWER INPUT : This cable is to be Plugged into the AC mains power outlet.
The input AC volts range is 90V to 240V, 50Hz/60Hz supply.
11)S-VIDEO : Used to connect the receiver via S-VIDEO to Input such as TV Sets.
4.B. REAR PANEL
4. HARDWARE DESCRIPTION
1) POWER : This key is used to turn the receiver on and off (stand by).
2) CH : These keys are used to change the channels.
3) VOL : These keys are used to increase and decrease the volume
level manually.
4) INFRARED SENSOR : This is to receive the IR commands from the
RCU. Do not block the view of the sensor.
5) 7 SEGMENT DISPLAY : This SEGMENT display will show the current
channel number.While the receiver is in stand by mode, the display will show
the current time.
POWER
C H
VOL
INFRARED SENSOR
7 SEGMENT DISPLAY
6) LED DISPLAY: This LED display will show the current power mode status.
If receiver is in stand by mode,stand by mode LED will be on. and when
receiver is in on mode, on mode LED will be on.
(Option for LED display model only)
LED DISPLAY
