520303
10
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
10
GB
HOW TO MEASURE HEART RATE
Select either display mode in HEART RATE. The indicator will
flash with the heart rate captured and the measurement will start from
0. The measuring range is 25 to 240 beats per minute.
When no signals are received or the measurement is out of range for
five minutes, the receiver will disable the function and return to the
previous operating mode automatically.
When the heart rate is displayed, you can go to other functions while
measuring the heart rate in the background.
Note:
When you are measuring your heart rate, keep the watch away from
signal generated sources e.g. PC, Television, car engine etc., othe
wise irregular signal will be observed.
HOW TO SET HEART RATE LIMITS
The heart rate limits help you determine if you are exercising within
your training zone. There are five preset training zones for you to
select or you can set them between 50 to 240 beats per minute. You
may select the preset training zone or alter the setting on the unit or
through the PC software (To connect the watch to the PC software
please refers to Section 7). When the heart rate alert alarm is
activated, an audible beep sound will flash whenever you go above
or below your limits.
Refer to fig 14 to set the heart rate limits and the heart rate alert alarm.
Note:
a) The upper limit must be set higher than the lower limit.
b) The alarms may also set through the PC software. To connect the
watch to the PC software please refers to Section 7.
HEART RATE HISTORY
Your OUTBREAKER is capable of retaining 99 heart rate records.
Each record contains:
A time and date stamp
Average heart rate and total exercise time
Upper limit and time above limit
Lower limit and time below limit
Time within limit
Refer to fig 13a to scroll on the records.
Note:
When a record is selected, the information embedded in the record
will be scrolled automatically.
SECTION 6 THE BICYCLE COMPUTER
This section applies to OUTBREAKER PRO only.
Before operating the bicycle computer, attached the bicycle computer
to the receiver as shown in diagram D-E.
Note:
a) The maximum distance between the sensor magnet and sensor
should be 5 mm (3/16 inches).
b) To ensure a secure signal transmission between the sensor
magnet and sensor, the centre of the magnet should be aligned
with the marker on the sensor.
c) The sensing distance between the wireless speedometer sensor
and the handlebar cradle is around 1 m (39 inches).
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Oregon Scientific ATP108 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info