Bedienungsanleitung Oregon Scientific EMR812 (Seite 6 von 10) (Englisch)

589230

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

display. The respective HI, LO or both indicators will light up

to signify the status of the alarm.

When an alarm activates, the display will switch to the respective

channel with the display flashing. If undisturbed, it will alarm for

one minute. Press any key to momentarily mute the alarm. It will

alarm again if the temperature continues to exceed the set limit.

To disable an alarm altogether, select the channel and use TEMP

AL ON/OFF to turn it off.

If you have set the upper and lower temperatures for more than one

channel and the limits are exceeded, the alarm will activate with the

display switching from one channel to another at five seconds

intervals.

TRANSMISSION COLLISION

Signals from other household devices, such as door bells, home

security systems and entry controls, may interfere with those of

this product and cause temporarily reception failure. This is nor-

mal and does not affect the general performance of the product. The

transmission and reception of temperature readings will resume

once the interference recedes.

NOTE ON °C AND °F

The unit of temperature display is selected on the °C/°F slide

switch. Select °C for Centigrade or °F for Fahrenheit.

Note : The remote temperature display on the main unit is domi-

nated by the selection on the °C/°F slide switch of the main unit.

Whatever the display units of the remote sensors are, they will be

automatically converted to the chosen one of the main unit.

To clear the memory, press CLEAR. All segments of the display

will light up for two seconds. The display will return to the last

screen with maximum and minimum temperature erased from

memory.

If you press MEM now, the maximum and minimum temperatures

will have the same values as the current ones until different read-

ings are recorded.

HOW TO USE TEMPERATURE ALARMS

The temperature alarms allow you to set the upper and lower limits

of readings for individual channels. The alarm will activate if a

limit is exceeded. To set the alarm,

1. Select the channel to be set.

2. Press the HI/LO button for the upper (HI) or lower (LO) limit.

An “OFF” message will be displayed if the alarm for that limit

is turned off.

3. Use the ADVANCE (

) button to set the upper or lower tem-

perature.

If this is the first time you set the limits, the lower limit will start

from -50°C (-58°F) and the upper limit +70°C (158°F). Other-

wise, the reading will start from the temperature last selected.

Each press on the button will increase the temperature by one

degree. Holding on the button will step up the increment by

five.

4. Press TEMP AL ON/OFF button to switch on or off the Max./

Min. temperature alarm. The set limit will be displayed.

5. Press HI/LO button to set another limit or return to normal

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oregon Scientific EMR812 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info