Bedienungsanleitung Oregon Scientific SH201 (Seite 12 von 201) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch)

796567

Zoom out

Zoom in

Vorherige Seite

1/201

Nächste Seite

NOTE To switch from digital to

analog or analog to digital system,

press the chest belt button for

more than 4 seconds and then

force a signal search.

IMPORTANT If “HR ---“ is displayed because no signal

has been found, press and hold MODE/- to force a signal

search.

In the event that you experience a weak signal or your signal

is disrupted by interference in the environment, follow the

instructions below to identify and resolve the situation.

1. The signal is weak - the watch heart rate monitor will

only show “0”:

• Shorten the distance between the heart rate chest

belt and watch.

• Re-adjust the position of the heart rate chest belt.

• Check the conductive pads are moist enough to

ensure solid contact.

• Check the batteries. If they are low or exhausted,

the transmission range may be shortened.

• Press and hold MODE/- to force a signal search.

2. The gym equipment does not seem to work with your

chest belt and the digital icon is displayed:

• Most gym equipment is compatible with the analog

system . Press and hold the chest belt button

for more than 4 seconds to change from digital to

analog. Then press and hold MODE/- to force a

signal search.

3. Interference from another person’s heart rate monitor

- their heart rate readings appear on your watch, or the

heart rate monitor shows “0”:

• Press the chest belt button to get the watch to

receive your chest belt signal. Do not press and

hold the chest belt button, as it will change the

transmission signal from digital to analog.

4. The signal is jammed - the heart rate reading on your

watch is ﬂashing:

• There is too much interference in the environment

for your heart rate monitor to function. Move to an

area where the heart rate reading stops ﬂashing.

WARNING Signal interference in the environment can be

caused by electromagnetic disturbances. These may occur

near high voltage power lines, trafﬁc lights, overhead lines

of electric railways, electric bus lines or trams, televisions,

car motors, bike computers, some motor driven exercise

equipment, cellular phones or when you walk through

electric security gates. Under interference, the heart rate

reading may become unstable and inaccurate.

NOTE If the watch is kept idle without receiving a heart rate

signal for half a minute, the heart rate mode will quit and

return to clock mode.

START EXERCISING

Before you start exercise, allow the watch a few seconds to

search for chest belt ﬁrst. This is to ensure you can receive

comprehensive calculations (such as your lap, calorie and

heart rate) during exercise.

Ensure HR zone or limits have been set and if doing pre-

programmed exercise, that the time conditions have been set.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oregon Scientific SH201 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info