Rearward facing use (0 - 10 kg)
DO NOT USE THIS CHILD SEAT ON A PASSENGER SEAT FITTED WITH AN AIR BAG!
When used rearward facing, the child seat must be in the fully reclined position.
Pull lap and diagonal sections of the car seat belt until fully extended and feed both
through the space between the shell and the base. Fasten the seat belt.
Thread the lap section through the guides located at the front of the base (8).
Thread the diagonal strap through the two upper guides located on the back of the
seat shell (9).
Tighten the seat belt by pulling first on the lap section, then on the diagonal one (10).
Check that there are no kinks or twists in the seat belt.
Lock the 2 sections of the belt with the blue lock-off clip. The lock-off should be posi-
tionned against the buckle of the seat belt (11).
Do not use the red lock-off for the rearward facing installation. Always keep the
seat in the most reclined position.
Forward facing use (9-18kg)
Fully recline the seat. Pull lap and diagonal sections of the car seat belt until fully
extended and feed both through the space between the shell and the base. Fasten the
seat belt (12).
Thread the lap section through the guides located below the red lock-off clips. Open the
red lock-off clip next to the buckle, then route the diagonal section of the belt through
the open lock-off clip (13).
Push the child seat right down into the car seat, and tighten both sections of the seat
belt by pulling the belt in the direction shown (14).
Close the lock-off across the diagonal belt (15).
Check that there are no kinks or twists in the seat belt.
Harness buckle
To fasten the harness, bring the two shoulder straps together (16) (17) and insert them
into the buckle; you should hear a “click” (18). To release the harness, press the buck-
le’s red button (19).
Fitting the harness
• To tighten the harness: Pull on the adjusting straps positioned on the harness. You
do not need to press on the adjuster buttons (20). IMPORTANT: A correctly adjusted
harness is essential for your child’s protection. There should not be more than finger’s
width between the harness and your child.
• To loosen the harness: Press on the adjuster buttons positioned on the upper section
of the harness, grasp the lower section and pull simultaneously (21).
Reclining your child seat
Push the adjustment lever located under the front of the seat upwards, then pull or
push the base towards or away from you (22).
