Bedienungsanleitung Otto Bock Dino 3 (Seite 18 von 88) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Schwedisch)

682694

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

Intended Use

The Dino® 3 mobility base for seating shells is designed solely for use with seating systems for people who are unable

to walk or who have a walking impediment. It can be moved either by the patient or by another person.

The Otto Bock Warranty applies only when the product is used according to the specied conditions and for the

intended purposes, following all manufacturer’s recommendations.

CE conformity

This product meets the requirements of the 93/42/EWG guidelines for medical products. This product has been

classified as a class I product according to the classification criteria outlined in appendix IX of the guidelines. The

declaration of conformity was therefore created by Otto Bock with sole responsibility according to appendix VII of the

guidelines.

Preface

Thank you very much for your decision to use an Otto Bock HealthCare product. In order to ensure that you will be

completely satisfied when using this product, please read the following instructions.

The design, as described in these Instructions for Use, is subject to technical alterations without notice. If there are

any questions, do not hesitate to ask your rehabilitation technology supplier.

The “Accessories” section (page 21) presents additional parts for the Dino® 3, which may extend the range of appli-

cation and increase comfort.

The “Adjustability / Assembly Instructions” section (page 23) describes the possibilities of adjusting the mobility base

to your individual requirements.

Safety Instructions

To avoid potentially dangerous situations such as tipping, you should become familiar with your new mobility base

with seating shell on level ground first.

Do not use the footrests as a stepstool when getting into or out of your mobility base with seating

shell.

Get to know how the mobility base reacts when the center of gravity shifts; for example on slopes or

inclines or when clearing obstacles, like steps and curbs. This should be done only with assistance from

another person. Using the anti-tipper is strongly recommended for untrained wheelchair users.

Park the mobility base with seating shell only on level surfaces. If you have to park it on an incline, make

sure that you bring the seat to an upright position because there is a risk that it can tip over backwards

when in a reclined position.

Please note, that the seat may only be tilted with the anti-tipper in operational position.

When reaching for objects in front, side or behind the wheelchair, be sure the patient does not lean out of

the seating shell too far since the shift in the center of gravity might cause the chair to tilt or tip over.

Use your mobility base with seating shell properly. For instance, do not jump it down from higher surfaces

and do not drive against obstacles (including steps, curbs) without braking.

The anti-tipper is a component that has been designed to prevent the wheelchair from tipping over

backwards. The anti-tipper should never be used to support the back of the wheelchair with the rear

wheels removed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Otto Bock Dino 3 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info