Bedienungsanleitung Oukitel WP10 (Seite 26 von 26) (Englisch)

789215

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Manufacturer's Name: SHENZHEN YUNJI INTELLIGENT

TECHNOLOGY CO.,LTD

Smart Phone

Model number: WP10

Operating Temperature: -10° C to 40° C

This device was tested for typical body-worn operations. To

comply with RF exposure requirements, a minimum separation

distance of 0mm must be maintained between the user’s body

and the handset, including the antenna. Third-party belt-clips,

holsters, and similar accessories used by this device should not

contain any metallic components. Body-worn accessories that

do not meet these requirements may not comply with RF

exposure requirements and should be avoided. Use only the

supplied or an approved antenna.

This device in compliance with the essential requirements and

other relevant provisions of Directive 2014/53/EU. All essential

radio test suites have been carried out.

1.Use careful with the earphone maybe possible excessive

sound pressure from earphones and headphones can cause

hearing loss.

2.CAUTION : RISK OF EXPLOSION IF BATTERY IS

REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED

BATTERIES ACCORDING TO THE INSTRUCTIONS

3.The product shall only be connected to a USB interface of

version USB 2.0

4.Adapter shall be installed near the equipment and shall be

easily accessible.

5.The plug considered as disconnect device of adapter

6.The device complies with RF specifications when the device

used at 0mm form your body

This device complies with part 15 of the FCC Rules. Operation is

subject to the condition that this device does not cause harmful

interference

Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate

the equipment.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception,which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

This Mobile Phone meets the government's requirements for exposure

to radio waves. The guidelines are based on standards that were

developed by independent scientific organizations through periodic and

thorough evaluation of scientific studies. The standards include a

substantial safety margin designed to assure the safety of all persons

regardless of age or health.

requirements, use accessories that maintain a 10mm separation

distance between the user's body and the back of the handset. The use

of belt clips, holsters and similar accessories should not contain

metallic components in its assembly. The use of accessories that do

not satisfy these requirements may not comply with FCC RF exposure

requirements, and should be avoided.

Body-worn Operation

This device was tested for typical body-worn operations. To comply

with RF exposure requirements, a minimum separation distance of

10mm must be maintained between the user’s body and the handset,

including the antenna. Third-party belt-clips, holsters, and similar

accessories used by this device should not contain any metallic

components. Body-worn accessories that do not meet these

requirements may not comply with RF exposure requirements and

should be avoided. Use only the supplied or an approved antenna.

FCC ID: 2ANMU-WP10

49 50

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oukitel WP10 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info