629378
50
Zoom out
Zoom in
Vorherige Seite
1/50
Nächste Seite
Version: 03/2013 Language: english
Innovative Mobile Technology
Operating instructions
HD receiver
„Europe“
Table of contents
2
1. General information
1.1 Introduction 3
1.2 Proper use and operation 5
1.3 Safety information 6
2. Control elements at receiver
2.1 Remote controls 8
2.2 Sat-mouse - operation without remote control 10
3. Operating the satellite system
3.1 Functions of the satellite system 11
3.2 Automatic search 13
3.3 Search via location 15
3.4 Manual search 16
3.5 Retract and switch off 18
3.6 Retract and deactivate 18
3.7 Edit settings 19
3.8 Internet Service (optional) 23
3.9 Fault messages 25
3.10 Reception in remote areas 27
4. Operating the receiver
4.1 Receiver menu tree 29
4.2 Channel list / editing 32
4.3 Channel list / scan 34
4.4 Edit settings 35
4.5 Options 36
4.6 Timer 38
5. Device layout and description
5.1 Connections 39
5.2 CI Common Interface module 40
5.3 Software update 41
5.4 Specifi cations of receiver 42
5.5 Declaration of conformity 43
6. Appendices
6.1 Channel and TV programme list 44
6.2 Appendix: Search satellites 47
6.3 Notes on protection of the environment 49
1.1 Introduction
Your ten Haaft® HDTV digital satellite reception system is a smart and fully auto-
matic system. It does not require any of the manual adjustments associated with
conventional systems. Unlike normal television antennas for terrestrial reception,
a satellite antenna always must be precisely aimed southward into the satellite‘s
signal beam. This signal beam must not be interrupted by trees or other obstacles,
as this will prevent reception.
Please ensure that the system always has a clear view to the satellite in the
South. If the signal is blocked – for example by a tree – it is quite possible
that a good satellite signal may be received without any problems in a position
just a few meters away. In Scandinavia, even mountains in the far distance can
interrupt the satellite signal.
Oyster® only
To allow reception even under such adverse conditions, the top-box (also called
„antenna unit“) of the Oyster® system can be removed from the vehicle top and be
set up near the vehicle in a position where a signal can be received. This requires a
special pedestal and an extension cable which are available as an optional „ground
kit“.
Satellite systems installed on buildings must usually only be adjusted once. By
contrast, a mobile system will need to be readjusted even if it is moved only a few
centimetres. Your ten Haaft® satellite system does this adjustment automatically at
the push of a button.
3
1.3 Safety information
To avoid the risk of fi re or damage to the device, the receiver must never be exposed
to moisture or rain.
Should an item or liquid get into the housing, immediately disconnect the de-
vice from the power supply and have it checked by a qualifi ed professional before
further usage.
Place the receiver in a place with suffi cient air circulation and away from
any heat sources. This will prevent heat accumulation inside the receiver and
ensures a longer lifecycle. Do not place any items on the receiver – malfunctions,
damage and even self-ignition may occur if the ventilation openings are blocked.
Should you ever notice an unusual smell or smoke, immediately disconnect the
device from the power supply and have it checked by a qualifi ed professional.
Switch off the receiver before connecting other devices. The power supply line to
the receiver must have a cross-section of 2.5 to 4,0 mm² and must be connected
directly to the vehicle battery. Ensure that the device is not connected to an elect-
ronic charge controller.
Keep a suffi cient distance to potential sources of interference such as mobile pho-
nes, electronic heater controllers, igniter components or radio devices when routing
the lines and positioning the components.
It is recommended that you ground your television set in the vehicle to avoid inter-
ference on your television set or satellite receiver. Only connect the freely accessible
ground of your television set to the vehicle chassis.
Only use the wiring harnesses supplied or the extension wiring harnesses available
as accessories to connect the top box. The extension wiring harnesses are available
for the Oyster® Digital system only.
6
7
Ensure that the opening motion of the antenna is not obstructed e.g. by a tree
or sign before folding out the antenna.
The driver of the vehicle must inspect the top-box before driving off to
ensure that the antenna is fully retracted.
The antenna may need up to 30 seconds to retract after the ignition is swit-
ched on or the engine is started. Do not move the vehicle during this period!
The antenna will only retract if the master switch at the receiver is set to ON
(or ‚I‘) and if the receiver is connected to a power source. Automatic retraction
may be prevented by technical defects of the vehicle or the antenna system.
Ensure that the antenna is fully retracted before driving off!
Ensure that the system is installed in your vehicle in accordance with the installati-
on instructions provided or have the correct installation confi rmed by the installer.
Please note that different legal requirements may apply to the operation of electri-
cal and electronic equipment in different countries. As the user of this equipment,
you are responsible for ensuring compliance with the relevant laws and regulations.
In case you are not familiar with the applicable legal regulations, we recommend
that you fully disconnect the satellite system from the power supply by turning off
the master switch of the receiver in order to avoid violating any applicable laws.
Keep in mind that all parts of this system may be dangerous to children. The swal-
lowing of small parts such as batteries can be fatal! Never leave children unat-
tended in the vicinity of the system or its components. Ensure that there are no
persons within the operating radius of the antenna when it is operated.
2.1 Remote controls
8
P+
OK
P-
-
+
TEL: +49(0)7237/4855-0
www.ten-haaft.com
Switches the receiver on and off (Power)
Mutes the sound
Activates sleep mode if pressed for more than 3 seconds
Number buttons for direct channel selection
Changes between TV and radio mode
Selects favourite channels list
Volume control
Channel up/down
Opens display menus
Returns to previously selected programme
Switches teletext mix-mode on and off
Shows current programme information (EPG)
Menu navigation up
Normal mode: Channel up/down
Menu navigation down
Normal mode: Channel up/down
Menu navigation left
Normal mode: Volume control
Menu navigation right
Normal mode: Volume control
Selects or confi rms functions
Opens the programme list
Closes on-screen menus / switches teletext off
Blank button
Displays the electronic programme guide (EPG)
Starts the teletext function of the receiver
9
P+
OK
P-
-
+
TEL: +49(0)7237/4855-0
www.ten-haaft.com
Selects sound options
Reverse
Forward
Starts playback
Interrupts playback
Starts the timeshift function
Stops playback
Starts the recording of a programme
Moves 5 minutes backward within the recorded programme
Moves 5 minutes forward within the recorded programme
Displays the recordings overview
Displays the timer list
Selects the video resolution of the HDMI output
CARO MA HDTV: Starts the satellite search menu
Oyster HDTV + I: Starts the satellite search /
Starts the Internet satellite search
Activates the loop-through for analogue and digital video and
audio signals
Opens the antenna system menu
2.2 Sat-mouse - operation without remote control
The two buttons on the sat-mouse allow you to control the following basic
functions of the receiver when the remote control is not
available:
When in stand-by mode, a brief press on both buttons switches the receiver back
on. When in „power-saving“ stand-by mode, the receiver can only be switched
on using the button combination.
Another control element is the master switch on the front of the receiver.
In position „0“ or „OFF“, the receiver is isolated from the vehicle‘s power supply.
The switch must be in position „I“ or „ON“ for the receiver to operate.
Should the receiver no longer respond to commands, set the master switch to „0“
for approx. 10 seconds and then back to „I“.
Changes to the next channel in the channel list.
Changes to the previous channel in the channel list.
Press both buttons briefl y at the same time to toggle between RADIO and TV mode. Holding
both buttons down will cause the receiver to switch off. This corresponds to pressing the red
stand-by button (ON/OFF) on the remote control.
Sat-mouse connector (RJ-45)
Remote control receiver
Left sat-mouse button
Right sat-mouse button
Display
1
4
2
5
3
1
2
3
4
5
10
ten Haaft GmbH
Oberer Strietweg 8
75245 Neulingen-Göbrichen
GERMANY
Phone + 49 (0) 72 37 / 48 55– 0
Fax + 49 (0) 72 37 / 48 55– 50
E-mail: info@ten-haaft.com
Office hours:
Monday – Friday 8:00 am – 12:00 am
1.00 pm – 4.30 pm
www.ten-haaft.com
50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Oyster Cosmo HDTV wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Oyster Cosmo HDTV

Oyster Cosmo HDTV Bedienungsanleitung - Deutsch - 52 seiten

Oyster Cosmo HDTV Bedienungsanleitung - Holländisch - 52 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info