Bedienungsanleitung P1PE P73200T (Seite 16 von 32) (Englisch)

779807

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

You MUST STOP using the machine if any of the following occur.

•The engine speed changes with no control.

•In case of misfire

•In case of high vibration.

If you are not familiar with this type of machine you should seek advice and guidance from your

dealer.

DO NOT attempt to lift or move the machine while the engine is running.

5.1. Machine use.

5.1.1. Position the machine in such a way that it cannot move during use, maintenance, cleaning,

adjustment, assembly of accessories or spare parts, as well as under storage. 5.1.2. DO NOT force

the machine. Use the correct machine for your application. The correct machine will do the job better

and safer at the rate for which it is designed.

5.1.3. DO NOT change the engine governor settings or over-speed the engine. The governor

controls the maximum safe operating speed of the engine.

5.1.4. DO NOT run the engine at a high speed when you are not using it.

5.1.5. DO NOT put hands or feet near the high pressure jet. Failure to observe these safety

instructions could result in serious injury.

5.1.6. Use only attachments and accessories approved by the manufacturer. Failure to do so can

result in personal injury, and may invalidate any warranty.

5.1.7. DO NOT allow persons unfamiliar with the machine or these instructions to operate it. This

machine is extremely is dangerous in the hands of untrained users.

5.2. Work area.

5.2.1. Thoroughly inspect the area to be worked, keep the working area clean and free of debris to

prevent tripping. Operate on a flat level ground.

5.2.2. NEVER place any part of your body where it would be in danger if movement should occur

during assembly, installation, and operation, maintenance, repairing or moving.

5.2.3. Keep all bystanders, children, and pets at least 23m (75 feet) away. If you are approached,

stop the unit immediately.

5.2.4. The operator or user is responsible for preventing accidents or hazards occurring to other

people, their property, and themselves.

5.2.5. Start the engine carefully according to instructions.

5.2.6. Before starting the pressure washer, make sure that the area to pressure washed is free of all

obstacles.

5.2.7. Whenever you leave the operating position you MUST always shut down the engine,

disconnect spark plug HT lead, keeping them away from the spark plugs to prevent accidental

starting, and wait for all moving parts to come to a complete stop.

5.2.8. ALWAYS stop the engine before moving the machine.

5.2.9. NEVER cover the machine while the exhaust is still hot.

5.2.10. NEVER operate the machine on slopes.

5.2.11. Move the machine at least 3m away from the refueling point before starting engine.

5.2.12. Inspect that all nuts and bolts are tight and well connected to ensure the safety and

5. USING THE MACHINE

Page 16

First edition - April 2017

The water must be turned on prior to starting the washer, pull the spray trigger to ensure water is

moving the through the lines and out the nozzle without any leaks before starting the unit. Failure to

do this will result in damage to the seals which will not be covered under warranty

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

P1PE P73200T Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info