Bedienungsanleitung Panasonic AG-DVX100B (Seite 83 von 88) (Englisch)

574346

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

Video Heads

Dirty video heads cause partial mosaic-pattern

noise or make the whole display bluish on playback.

When the video heads get extremely dirty, the

recording quality decreases, and, in the worst case,

it won’t record at all.

Causes of dirty video heads

• Dusty atmosphere

• High temperature and humidity

• Scratches on tapes

•Overuse

Using A Cleaning Tape

(1) Insert the cleaning tape in the camera recorder

and turn on the power switch

(2) Press the CAMERA/VCR button and make sure

the VCR lamp is on.

(3) Move the OPERATION lever q. Move it g

within ten seconds.

(Do not rewind the tape at this point.)

(4) Eject the cleaning tape and insert another tape.

Record on it and play it back. Make sure the

picture is fine.

(5) If the picture is not clear, repeat the steps 1-4.

(Do not use the cleaning tape more than four

times in a row.)

• Do not rewind the cleaning tape until it gets to the

end of the tape. When the tape gets to the end,

rewind it to the beginning to use it again.

• If the video head gets dirty soon after you clean it,

the cleaning tape might be damaged. Stop using

the cleaning tape right away.

• Overusing the cleaning tape might damage the

video head. If the video head is damaged, the

picture quality will not improve even when you

clean the video head.

• When you can’t clean a dirty video head with the

cleaning tape, it needs cleaning and repair at the

dealer. Please contact them.

Regular Maintenance

For the superior picture quality, we recommend

replacing consumable parts such as a video head

approximately every 2,000 hours of use.

(However, this estimated time varies greatly

depending on the environment in which it is used,

such as temperature, humidity, and dust.)

Cleaning

When cleaning, do not use benzene or thinner.

• Using benzine or paint thinners may deform the

camera-recorder and/or cause the surface finish

to peel off.

• Before proceeding with maintenance, remove the

battery or disconnect the AC cord from the power

outlet.

• Use a soft, clean cloth to wipe the camera-

recorder. To remove stubborn dirt, wipe the

camera-recorder with a cloth moistened with

kitchen detergent that has been diluted with water

and then use a dry cloth to take up the remaining

moisture.

Cleaning the Viewfinder

If there is dust inside the view finder, remove the

eye cap holder and get rid of the dust.

• The interior of the eye cap holder is specially

finished, so do not ever wipe it. If there is dust on

it, blow it off with an air blower.

• You can remove the eye cap holder by turning it

counterclockwise. When you do this, tilt the view

finder slightly upward.

• When you put the eye cap holder back on, hold it

so that the eye cap holder mark points upward,

then turn it clockwise to put it back on.

Mark

Eye cap holder

Reference

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic AG-DVX100B Seite 83

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info