Bedienungsanleitung Panasonic DMC-FZ20PP (Seite 41 von 128) (Englisch)

121039

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

Recording pictures (basic)

∫ Adjusting flash output

Adjust the flash output when the subject is

small or reflection ratio is extremely high or

low.

1 Press 3 several times until

[ FLASH] appears and then set

the flash output.

• You can adjust this from j2EV to

i2 EV in steps of 1/3 EV.

• The determined flash output is

memorized even if the camera is turned

off.

• In motion image mode [ ],

[SCENERY], [NIGHT SCENERY] or

[FIREWORKS] in scene mode (P58),

you cannot adjust the flash output.

• If the ISO sensitivity is set to [AUTO], it is

automatically adjusted from [ISO100] to

[ISO400] when you use the flash. (except

when the flash mode is set to Slow sync./

Red-eye reduction [ ]) To avoid

noise, decrease the ISO sensitivity.

• In [NIGHT PORTRAIT] in scene mode

(P58), flash setting is fixed to Slow sync./

Red-eye reduction [ ].

• In motion image mode [ ], [SCENERY],

[NIGHT SCENERY] or [FIREWORKS] in

scene mode (P58), the flash mode is fixed

to the Forced OFF [ ] even if the flash is

opened.

• Do not stare at the photo flash from

close proximity when using the flash.

• If you bring the flash too close to the

subjects, they may appear distorted or

discolored by its heat and lighting.

• Do not cover the photo flash with your

fingers or any other items.

• When you take a picture beyond the flash

control range, the exposure may not be

adjusted properly and the picture may

become bright or dark.

• When you repeat taking a picture,

recording may be disabled even if the

flash is activated. Take a picture after the

card access lamp disappears.

• When the jitter alert appears, we

recommend using the flash.

• When you set to burst mode or auto

bracket, only 1 picture is recorded for

every flash activated.

• The flash icon turns red when activating

the flash and pressing the shutter button

halfway.

• When the flash is being charged, the flash

icon blinks red, and you cannot take a

picture even when you press the shutter

button fully.

• When taking a picture with the flash,

we recommend removing the lens

hood. In some cases it may not allow

the scene to be illuminated properly.

• Do not close the flash soon after the flash

is activated prior to taking pictures due to

AUTO/Red-eye reduction etc. It causes a

malfunction.

• When taking a picture with the flash, the

white balance will be automatically

adjusted [except for [ ] (Daylight) and

[ ] (Flash)], but the white balance may

not be properly adjusted if the photo flash

is insufficient.

• When the shutter speed is fast, the flash

effect may not be sufficient.

• To avoid picture noise, we recommend

setting [NOISE REDUCTION] in

[PICT.ADJ.] to [HIGH] or setting the items

except [NOISE REDUCTION] to [LOW] to

take pictures. (P75)

• Refer to P70 for the ISO sensitivity.

FLASH

SELECT

EXIT

FZ20-PP.book 41 ページ２００４年７月６日　火曜日　午後２時６分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic DMC-FZ20PP Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info