Bedienungsanleitung Panasonic ey 7541 ln (Seite 9 von 140) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

381498

Zoom out

Zoom in

Vorherige Seite

1/140

Nächste Seite

• When the battery pack is removed from the

main body of the tool, replace the battery

pack cover immediately in order to prevent

dust or dirt from contaminating the battery

terminals and causing a short circuit.

Battery Pack Life

The rechargeable batteries have a lim-

ited life. If the operation time becomes

extremely short after recharging, replace

the battery pack with a new one.

Battery Recycling

ATTENTION:

For environmental protection and recy-

cling of materials, be sure that it is dis-

posed of at an officially assigned loca-

tion, if there is one in your country.

[Battery Charger]

Charging

Cautions for the Li-ion Battery

Pack

• If the temperature of the battery pack falls

approximatelybelow−10°C(14°F),charg

ing will automatically stop to prevent degra-

dation of the battery.

Common Cautions for the Li-

ion/Ni-MH/Ni-Cd Battery Pack

• The ambient temperature range is between

0°C (32°F) and 40°C (104°F).

If the battery pack is used when the bat

tery temperature is below 0°C (32°F),

the tool may fail to function properly.

• When charging a cool battery pack (below

0°C (32°F)) in a warm place, leave the

battery pack at the place and wait for

more than one hour to warm up the bat-

tery to the level of the ambient tempera-

ture.

•

Cool down the charger when charging more

than two battery packs consecutively.

• Do not insert your fingers into contact

hole, when holding charger or any other

occasions.

CAUTION:

To prevent the risk of fire or damage to

the battery charger.

• Do not use power source from an

engine generator.

• Do not cover vent holes on the charger

and the battery pack.

• Unplug the charger when not in use.

Li-ion Battery Pack

NOTE:

Your battery pack is not fully charged at

the time of purchase. Be sure to charge

the battery before use.

Battery charger (EY0L80)

1. Plug the charger into the AC outlet.

NOTE:

Sparks may be produced when the plug

is inserted into the AC power supply, but

this is not a problem in terms of safety.

Insert the battery pack firmly into the charger.

1 Line up the alignment marks and place the

battery onto the dock on the charger.

2 Slide forward in the direction of the arrow.

Alignment marks

During charging, the charging lamp will be

lit.

When charging is completed, an internal

electronic switch will automatically be trig-

gered to prevent overcharging.

• Charging will not start if the battery

pack is warm (for example, immediately

after heavy-duty operation).

The orange standby lamp will be flash

ing until the battery cools down.

Charging will then begin automatically.

The charge lamp (green) will flash slowly

once the battery is approximately 80%

charged.

When charging is completed, the charging

lamp will start flashing quickly in green color.

6. If the temperature of the battery pack is

0°C or less, charging takes longer to fully

charge the battery pack than the standard

charging time.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic ey 7541 ln Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info