Read “the Safety Instructions” booklet
and the following before using.
I.
ADDITIONAL SAFETY
RULES
1) Be aware that this tool is always in an oper-
ating condition, since it does not have to be
plugged into an electrical outlet.
2)
When screwing or driving into walls, floors,
etc., “live” electrical wires may be encoun
-
tered. DO NOT TOUCH THE HEX QUICK
CHUCK OR ANY FRONT METAL PARTS
OF THE TOOL! Hold the tool only by the
plastic handle to prevent electric shock in
case you screw or drive into a “live” wire.
3)
If the screw driver does not rotate anymore,
immediately turn the main switch off for a
longer period to prevent an overload, which
can damage the battery pack or motor.
Use reverse motion to loosen jammed bits.
4)
Do NOT operate the Forward/Reverse lever
when the main switch is on. The battery will
discharge rapidly and damage to the unit
may occur.
5)
During charging, the charger may become
slightly warm. This is normal.
Do NOT charge the battery for a long period.
6) Use only a dry, soft cloth to wipe the unit. Do
NOT use a damp cloth, thinner, benzine, or
other volatile solvents for cleaning.
7)
When storing or carrying the tool, set the
Forward/Reverse lever to the center position
(switch lock).
8)
Do not strain the tool by holding the speed
control trigger halfway (speed control mode)
so that the motor stops.
9)
Young children should be supervised to
ensure that they do not play with the appliance.
10)Wear ear protectors when using the tool for
extended periods.
II. ASSEMBLY
Attaching or removing bit
NOTE:
•
When attaching or removing a bit, discon-
nect battery pack from tool or place the
switch in the center position (switch lock).
1. Hold the collar of quick connect chuck and
pull it against the driver.
2. Insert the bit into the chuck.
3. The collar will return to its original position
when it is released.
4.
Pull the bit to make sure it does not come out.
5. To remove the bit, pull back on the collar
in the same way.
CAUTION:
• If the collar does not return to its origi-
nal position or the bit comes out when
pulled on, the bit has not been properly
attached. Make sure the bit is properly
attached before use.
Use 6.35mm (1/4”) hexagonal bits.
To ensure proper securement of the bit, use
only hexagonal bits with 9.5mm (3/8”) detent.
6.35mm (1/4”)
9.5mm (3/8”)
Attaching or removing
battery pack
1. To connect the battery pack:
Insert the battery pack. It snaps into place
to indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides of the
battery pack. Slide the battery pack out of
the tool body.
III. OPERATION
Switch and Forward / Reverse
lever Operation
(Forward, Lock, Reverse)
CAUTION:
•
To prevent damage, do
not operate Forward/
Reverse lever until the bit
comes to a complete stop.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to start
the tool slowly.
3. The speed increases with the amount of
depression of the trigger for efficient tight
-
ening of screws. The brake operates and
the bit stops immediately when the trigger
is released.
4. After use, set the lever to its center posi-
tion (switch lock).
Reverse Rotation Switch
Operation
1.
Push the lever for reverse rotation. Check
the
direction of rotation before use.
2.
Depress the trigger switch slightly to start the
tool slowly.
3. After use, set the lever to its center posi-
tion (switch lock).
