Original instructions: English
Translation of the original instructions:
Other languages
I. INTENDED USE
These tools can be used to tighten
screws in clutch mode and to drill
holes in wood and metal in drill mode.
Additionally, model EYFEA1N can be
used to drill holes in soft concrete and
similar materials in hammer mode.
Read the Safety Instructions booklet
and the following before using.
II. ADDITIONAL
SAFETY RULES
1) Wear ear protectors.
Exposure to noise can cause hearing loss.
2) Use auxiliary handle supplied with
the tool.
Loss of control can cause personal injury.
3) Hold power tools by insulated
gripping surfaces when per-forming
an operation where the cutting tool
may contact hidden wiring; contact
with a “live” wire will make exposed
metal parts of the tool “live” and shock
the operator.
4) Wear a dust mask, if the work causes dust.
5) Be aware that this tool is always in an
operating condition, since it does not have
to be plugged into an electrical outlet.
6) When drilling or driving into walls,
oors, etc., “live” electrical wires may
be encountered. DO NOT TOUCH
THE CHUCK OR ANY FRONT METAL
PARTS OF THE TOOL! Hold the tool
only by the plastic handle to prevent
electric shock in case you drill or drive
into a “live” wire.
7) If the bit becomes jammed, im-mediately
turn the trigger switch off to prevent an
overload, which can damage the battery
pack or motor. Use reverse motion to
loosen jammed bits.
8) Do NOT operate the For-ward/Reverse
lever when the trigger switch is on. The
battery will discharge rapidly and dam-
age to the unit may occur.
9) During charging, the charger may
become slightly warm. This is normal.
Do NOT charge the battery for a long
period.
10) When storing or carrying the tool,
set the Forward/Reverse lever to the
center position (switch lock).
11) Do not strain the tool by holding the
speed control trigger halfway (speed
control mode) so that the motor stops.
12) Do not operate the speed selector
switch (LOW-HIGH) while pulling on
the speed control trigger. This can
cause the rechargeable battery to
wear quickly or damage the in-ternal
mechanism of the motor.
WARNING
Do not use other than the Panasonic bat-
tery packs that are designed for use with
this rechargeable tool.
Panasonic is not responsible for any dam-
age or accident caused by the use of recy-
cled or counterfeit battery pack.
Do not dispose of the battery pack in a re,
or expose it to excessive heat.
Do not drive the likes of nails into the bat-
tery pack, subject it to shocks, dismantle it,
or attempt to modify it.
Do not allow metal objects to touch the bat-
tery pack terminals.
Do not carry or store the battery pack in the
same container as nails or similar metal
objects.
Do not charge the battery pack in a high-
temperature location, such as next to a re
or in direct sunlight. Otherwise, the battery
may overheat, catch re, or explode.
Never use other than the dedicated charg-
er to charge the battery pack. Otherwise,
the battery may leak, overheat, or explode.
After removing the battery pack from the
tool or the charger, always reattach the
pack cover. Otherwise, the battery contacts
could be shorted, leading to a risk of re.
When the Battery Pack Has Deteriorated,
Replace It with a New One. Continued use
of a damaged battery pack may result in
heat generation, ignition or battery rupture.
