Bedienungsanleitung Panasonic HC-V130P (Seite 95 von 100) (Englisch)

588941

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

- 95 -

When the status indicator is flashing at a

particularly fast or slow rate, the following

should be considered.

Flashing with approx. 4 second period (off

for approx. 2 seconds, on for approx. 2

seconds):

≥ When the battery is over discharged or the

temperature of the battery is too high or low.

It can be charged, but it may take a few hours

to complete the charging normally.

≥ It will flash in approx. 2 second intervals

when normal charging resumes. Even in such

cases, it may start flashing in approx.

4 second intervals until charging is completed

depending on the conditions of use.

Flashing with approx. 0.5 second period (off

for approx. 0.25 second, on for approx. 0.25

second):

≥ The battery is not charged. Remove the

battery from the unit, and try charging again.

≥ Check that the terminals of the unit or battery

are not dirty or covered with a foreign object,

and connect the battery correctly once again.

If a foreign object or dirt is present, turn off

the unit before removing.

≥ The battery or environment is at an extremely

high or low temperature. Wait until the

temperature has returned to an appropriate

level and try charging again. If you are still

unable to charge, there may be a fault in the

unit, battery or AC adaptor.

Off:

≥ Charging has finished.

≥ If the status indicator stays off despite the

charging being unfinished, there may be a

fault in the unit, battery or AC adaptor. Refer

to page 94 for details on the battery.

When disposing of or giving away the SD

card, note that:

≥ Formatting and deletion of this unit or

computer only changes the file management

information and does not completely delete

the data in the SD card.

≥ It is recommended that the SD card is

physically destroyed or the SD card is

physically formatted using this unit when

disposing of or giving away the SD card.

For the physical format, connect the unit to

the AC adaptor, select [SETUP] # [FORMAT

MEDIA] # [YES] from the menus, and then

press and hold down the Recording start/stop

button for approximately 3 seconds on the

screen below. When the SD card data

deletion screen appears, select [YES], and

then follow the on-screen instructions.

≥ When the LCD screen is dirty or

condensation has occurred, please wipe it

using a soft cloth such as eyeglass cleaner.

≥ When the unit has become very cold, for

example due to storage in a cold area, its

LCD monitor will be slightly darker than usual

immediately after the unit is turned on. The

normal brightness will be restored when the

unit’s internal temperature rises.

About status indicator during

charging

About the SD card

LCD monitor

Extremely high precision technology is

employed to produce the LCD Monitor

screen. The result is more than 99.99%

effective dots with a mere 0.01% of the dots

inactive or always lit. However, this is not a

malfunction and does not affect the recorded

picture.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic HC-V130P Seite 95

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic HC-V130P

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info