Bedienungsanleitung Panasonic HDC-HS80 (Seite 134 von 148) (Englisch)

502143

134

Zoom out

Zoom in

Vorherige Seite

1/148

Nächste Seite

134

VQT3J26

When the status indicator is flashing at a

particularly fast or slow rate, the

following should be considered.

Flashing with approx. 4 second period

(off for approx. 2 seconds, on for approx.

2 seconds):

≥ When the battery is over discharged or the

temperature of the battery is too high or

low. It can be charged, but it may take a

few hours to complete the charging

normally.

≥ It will flash in 2 second intervals when

normal charging resumes. Even in such

cases, it may start flashing in 4 second

intervals until charging is completed

depending on the conditions of use.

Flashing with approx. 0.5 second period

(off for approx. 0.25 second, on for

approx. 0.25 second):

≥ The battery is not charged. Remove the

battery from the unit, and try charging

again.

≥ Check that the terminals of the unit or

battery are not dirty or covered in a foreign

object, and connect the battery correctly

once again. If a foreign object or dirt is

present, turn off the unit before removing.

≥ The battery or environment is at an

extremely high or low temperature. Wait

until the temperature has returned to an

appropriate level and try charging again. If

you are still unable to charge, there may

be a fault in the unit, battery or AC

adaptor.

Off:

≥ Charging has finished.

≥ If the status indicator stays off despite the

charging being unfinished, there may be a

fault in the unit, battery or AC adaptor.

Refer to page 133 for details on the

battery.

When disposing of or giving away the SD

card, note that:

≥ Formatting and deletion of this unit or

computer only changes the file

management information and does not

completely delete the data in the SD card.

≥ It is recommended that the SD card is

physically destroyed or the SD card is

physically formatted using this unit when

disposing of or giving away the SD card.

To physically format the SD card, connect

the unit via the AC adaptor, select

[SETUP] # [FORMAT CARD] # [YES]

from the menu, and then press and hold

the recording start/stop button on the

screen below for about 3 seconds. When

the SD card data deletion screen appears,

select [YES], and then follow the

on-screen instructions.

To physically format the SD card, connect

the unit via the AC adaptor, select

[SETUP] #[FORMAT MEDIA] # [SD

CARD] from the menu, and then press

and hold the recording start/stop button on

the screen below for about 3 seconds.

When the SD card data deletion screen

appears, select [YES], and then follow the

on-screen instructions.

≥ The customer is responsible for the

management of the data in the SD card.

About status indicator during

charging

About the SD card

HDCSD80&TM80&HS80EB-VQT3J26_mst.book 134 ページ２０１１年１月１１日　火曜日　午前１１時４４分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic HDC-HS80 Seite 134

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic HDC-HS80

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info