78
To record your own greeting
message with function menu
1 Press (INT) then .
2 After the function menu is displayed,
press or until the arrow points to
“Record”, then press .
3 While “Record OGM” is at the arrow,
press .
4 After the long beep, talk clearly, about
20 cm away from the MIC (microphone) on
the handset.
•During recording, the arrow points to
“Stop”.
5 When finish recording, press .
•A recording of your own greeting message is
played back.
•The display will return to “Remote
Operation”. To return to the standby
mode, press or wait for 30 seconds.
Answering System Operations with the Handset
For basic answering system operation, see page 17.
You can operate the answering system by function menu or by pressing dialling button as direct
command.
All messages (greeting, incoming, and memo) are stored indefinitely on a “Flash memory”
IC chip – even if a power failure occurs. All of the messages are saved until you erase them – Flash
Memory Message Backup.
Greeting Message
The total recording time (include audible caller ring) is approximately 15 minutes. Any recorded
noise may shorten the recording time up to 3 minutes. The greeting recording time is limited to
2 minutes and 30 seconds. We recommend you to record a brief greeting message in order to
leave more time for recording new messages.
To record your own greeting
message with direct command
1 Press (INT) then .
2 Press then .
3 After the long beep, talk clearly, about
20 cm away from the MIC (microphone)
on the handset.
•The display will start showing the length of
the recording time.
4 When finish recording, press .
•A recording of your own greeting message
is played back.
•The display will return to “Remote
Operation”. To return to the standby
mode, press or wait for 30
seconds.
