95
Chapter 6Multi-Unit User Operations
Registration
Registering a Handset in the Base Unit
You must register the handset in the base unit before use.
1 Handset:
Press .
2 Press or until the arrow points
to “Setting Handset”, then press
.
3 Base unit where handset is to be
registered :
Press and hold on the base unit
for more than 10 seconds until a
registration tone sounds.
4 Handset:
Press or until the arrow points
to “Registration”, then press .
5 Press or until the arrow points
to “Register H/set”, then press
.
•The available base unit numbers are
displayed.
6 Press or to select the desired
base unit number, then press .
•The number is assigned as the base unit
number for the handset.
•Charge the optional handset batteries for approximately 15 hours before initial use.
•Make sure that the power is ON (p. 15) and the unit is in the standby mode.
•Register the handset number within 1 minute. If not registered within 1 minute, press on the
handset to cancel the programming mode. Then start over again from step 1.
7 Enter the 4-digit base unit PIN (p. 67).
8 Press .
•“Please Wait...” is displayed, then
a confirmation tone sounds.
•The handset will return to the standby
mode. The current connected base unit
number will be displayed.
•To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
•You can exit the programming mode any time
by pressing .
•The base unit number which the handset is
currently in contact with can be displayed in
the standby mode (p. 59). Calls (both incoming
and outgoing) can be conducted only via the
displayed base unit (even if the radio areas
overlap with neighbouring base units).
Base 1
10 New Calls
12.05 13:58
Enter Base PIN
:
-
Please Wait...
KX-TCD735EM(E)-4(76~100) 01.10.22 16:16 Page 95
