Bedienungsanleitung Panasonic kx tg 9120 9127 (Seite 50 von 68) (Englisch)

300502

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Multi-unit Operation

Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333

Operating additional units

Additional handsets

Up to 6 handsets can be registered to a

single base unit.

Important:

L The additional handset model

recommended for use with this unit is

noted on page 4. If other model handset is

used, certain operations (handset

settings, base unit settings, etc.) may not

be available.

L Additional handsets will give you the

freedom to, for example, have an intercom

call with another handset while a third

handset is on an outside call.

Additional base units

Handsets can be registered to up to 4 base

units, allowing you to add additional base

units and extend the area in which your

handset(s) can be used. If a handset moves

out of range of its base unit when “Auto” is

selected on base unit selection (page 51), it

will look for another base unit to make or

receive calls. A base unit and the handsets it

communicates with is called a “radio cell”.

Note:

L Calls will be disconnected when the

handset moves from one radio cell to

another.

Registering a handset to a

base unit

The included handset and base unit are

preregistered. If for some reason the

handset is not registered to the base unit (for

example, w flashes even when the handset

is near the base unit), register the handset

manually (page 50).

To register an additional handset to a

base unit (easy registration)

After purchasing an additional handset,

additional handset is switched on. If it is not

on, press and hold {ih} for few seconds

to turn the handset on.

1 Lift the additional handset and press

{ih} to put the handset in standby

mode.

2 Press and hold {x} on the base unit for

about 3 seconds, until the registration

tone sounds.

3 Place the additional handset on the

base unit. The registration tone

continues to sound. With the handset

still on the base unit, wait until a

confirmation tone sounds and w stops

flashing.

Note:

L If an error tone sounds, or if w is still

flashing, register the handset manually

(manual registration; page 50).

L If all registered handsets start ringing in

step 2, press {x} to stop. Start again from

step 1.

L Charge the batteries of your additional

handset for about 7 hours before initial

use.

L This registration method cannot be used

for handsets that have already been

registered to a base unit. Register the

handset manually (manual registration;

page 50).

To register a handset to an additional

base unit (manual registration)

You can register a handset to a base unit

manually using the following method.

1 J (centre of joystick) i m i L

2 “Registration” i L

3 “Register H.set” i L

4 Select a base unit number. i L

TG9120_40_50E(e).book Page 50 Wednesday, August 2, 2006 4:54 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic kx tg 9120 9127 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info