Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
R Set the date and time beforehand
(page 12).
1 M N
2 MbN: “Handset Setup” a M
N
3 MbN: “Alarm” a M
N
4 MbN: Select the desired alarm option. a
M
N
“Off”
Turns alarm off. Go to step 8.
“Once”
An alarm sounds once at the set time.
“Daily”
An alarm sounds daily at the set time.
Go to step 6.
5 Enter the desired date and month.
6 Set the desired time. a M N
7 MbN: Select the desired alarm tone. a
M
N
R We recommend selecting a different
ringer tone from the one used for
outside calls.
8 M
N a M N
R When the alarm is set,
is displayed.
Note:
R To stop the alarm, lift the handset and
press M
N or place the handset on the
base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Changing the unit’s region
setting/Resetting the base unit
1 M
N
2 MbN: “Base Unit Setup” a M
N
3 MbN: “Country” a M N
4 MbN: Select the desired country. a
M
N
“Other” = countries except Czech and
Slovakia
“Česká republika” = Czech
“Slovensko” = Slovakia
5 MbN: “Yes” a M
N a M N
Note:
R The following items will be deleted or reset
to their default settings:
– Base unit settings (page 19)
– One touch eco mode (page 13)
– Caller list
– Voice mail messages
R The following items will be retained:
– Date and time
– Repeater mode
R If you select the desired country in step 4,
the following default settings will be
changed for the selected country’s default
settings:
– Recall/flash time (page 19)
– Display language (page 18)
R After changing the unit’s region setting/
resetting the base unit,
may flash on the
handset momentarily. This is normal and
the handset can be used once
stops
flashing.
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
20
Programming
