used, certain operations may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1 Handset:
M
N#130
2 Base unit:
Proceed with the operation for your model.
n KX-TG6811 series: page 3
Press and hold M N for about 5
seconds. (No registration tone)
n KX-TG6821 series: page 3
Press and hold M
N for about 5
seconds, until the registration tone
sounds.
R If all registered handsets start ringing,
press M
N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
3 Handset:
MOKN a Wait until “Base PIN” is
displayed. a Enter the base unit PIN
(default: “0000”). a MOKN
R If you forget your PIN, contact an
authorised service centre.
R When the handset has been registered
successfully,
is displayed.
Note:
R While registering, “Base in
registering” is displayed on all
registered handsets.
R When you purchase an additional handset,
refer to the additional handset’s installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1 M N#131
R All handsets registered to the base unit
are displayed.
2 MbN: Select the handset you want to
cancel. a MOKN
3 MbN: “Yes” a MOKN
R A confirmation tone sounds.
R The handset does not beep when
cancelling its own registration.
4 MeN
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 5. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1 M
N#138
2 MbN: Select the desired setting. a MOKN
a MeN
Note:
R After turning the repeater mode on or off,
may be displayed on the handset
momentarily. This is normal and the
handset can be used once
is displayed.
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1 Base unit:
Proceed with the operation for your model.
35
Programming
