Changing the handset name
Each handset can be given a
customised name (“Bob”, “Kitchen”,
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is “No”. If you
select “Yes” without entering any
handset name, “Handset 1” to
“Handset 6” is displayed.
1 MMENUN#104
2 Enter the desired name (max. 10
characters; see the character table,
page 26).
R If not required, go to step 3.
3 MSAVEN
4 MbN: Select the desired setting. a
MSELECTN 2 times
5 MOFFN
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
when:
– the unit receives a call from a phone
number stored in the call barred list as
unwanted (“Storing unwanted callers”,
page 37).
– the unit receives a call without phone
number (“Call barring incoming calls
without phone number”, page 37).
When a call is received, the unit rings for
a short time while the caller is being
identified. If the phone number matches
an entry in the call barred list:
– cellular calls are rejected.
– landline calls are disconnected after
the unit first sends out a busy tone to
the caller.
Important:
R When the unit receives a call from a
number that is stored in the call
barred list or a call without a
recognised phone number, the call is
logged in the caller list (page 42)
with
after the call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers
in the call barred list.
Important:
R You must store the phone number
with an area code in the call barred
list.
n From the caller list:
1 MFN CID
2 MbN: Select the entry to be barred.
3 MSAVEN
4 MbN: “Caller barred” a
MSELECTN
5 MbN: “Yes” a MSELECTN
6 Edit the phone number if
necessary (24 digits max.).
7 MSAVEN a MOFFN
n By entering phone numbers:
1 MMENUN#217 a MADDN
2 Enter the phone number (24
digits max.).
R To erase a digit, press
MCLEARN.
3 MSAVEN a MOFFN
Call barring incoming calls without
phone number
You can reject a call when no phone
number is provided, such as a call just
showing “Out of area”.
1 MMENUN#240
2 MbN: Select the desired setting. a
MSAVEN a MOFFN
37
Programming
