Error messages
Display message Cause/solution
Base no power
or
No link to base.
Reconnect main base
AC adaptor.
or
No link.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset’s registration may have been cancelled.
Re-register the handset (page 30).
R When “No link.” is displayed during a power failure, place a
handset on the base unit to supply power to the base unit.
Check Phone Line
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
Error
R Recording was too short. Try again.
Failed
R Phonebook copy failed (page 22). Confirm the other handset
(the receiver) is in standby mode and try again.
Incomplete
R The receiver’s phonebook memory is full. Erase the unwanted
phonebook entries from the other handset (the receiver) and
try again.
Memory Full
R The phonebook memory is full. Erase unwanted entries
(page 21).
R Message memory is full. Erase unwanted messages (page 36,
37).
R The call barred list memory is full. Erase unwanted entries
(page 29).
Use rechargeable
battery.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
You must first
subscribe to Caller
ID.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
47
Useful Information
