Bedienungsanleitung Panasonic KX-TG8093 (Seite 27 von 40) (Englisch)

106277

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Multi-unit Operation

Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333

Operating additional units

Additional handsets

Up to 5 handsets can be registered to a single

base unit.

Important:

L The additional handset model recommended for

use with this unit is noted on page 4. If other

model handset is used, certain operations

(handset settings, base unit settings, etc.) may

not be available.

L Additional handsets will give you the freedom to,

for example, have an intercom call with another

handset while a third handset is on an outside

call.

Additional base units

Handsets can be registered to up to 4 base units,

allowing you to add additional base units and

extend the area in which your handset(s) can be

used. You need to select the desired base unit to

use the handset with (page 27).

Registering a handset to a

base unit

The supplied handset and base unit are pre-

registered. If for some reason the handset is not

registered to the base unit (for example, w flashes

even when the handset is near the base unit),

1 Press and hold {x} on the base unit for about

5 seconds until a beep is heard.

L If all registered handsets start ringing, press

{x} to stop, then repeat this step.

L After a beep is heard, the rest of this

procedure must be completed within 1

minute.

2 {MENU} (right soft key) i r i {OK}

3 {^}/{V}: “Registration” i {OK}

4 {^}/{V}: “Register Handset” i {OK}

5 {^}/{V}: Select a base unit number. i {OK}

L This number is used by the handset as a

reference only.

L The registered base unit is indicated by “@”.

6 “Enter PIN” is displayed. Enter the base unit

PIN (default: “0000”). i {OK}

L If you forget your PIN, consult your nearest

Panasonic service centre.

L When the handset has been registered

successfully, w will stop flashing. If the key

tone is turned on (page 16), a confirmation

tone will be heard.

Selecting a base unit

When a specific base unit is selected, the handset

will make and receive calls using that base unit

only. If the handset is out of range of that base unit,

no calls can be made.

1 {MENU} (right soft key) i r i {OK}

2 {^}/{V}: “Select Base” i {OK}

3 {^}/{V}: Select the desired base unit. i

{OK}

L The selected base unit is indicated by “t”

located on the left of the item on the display.

L The handset starts searching for the base

unit.

Deregistering a handset

A handset can cancel its own registration (or the

registration of another handset) that is stored in the

base unit. This will allow the base unit to “forget”

the handset.

1 {MENU} (right soft key) i r i {OK}

2 {^}/{V}: “Registration” i {OK}

3 {^}/{V}: “Deregistration” i {OK}

4 Enter the base unit PIN (default: “0000”). i

{OK}

L If you forget your PIN, consult your nearest

Panasonic service centre.

L The numbers of all handsets registered to

the base unit are displayed.

L The handset you are using is indicated by

“t” located on the left of the item on the

display.

5 {^}/{V}: Select the handset(s) you want to

cancel. i {OK}

6 {YES} i {i}

Note:

L “Register!” is shown on the handset display

when you cancel registration.

TG8070-8090E(e).book Page 27 Monday, June 11, 2007 8:12 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic KX-TG8093 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info